GE zbd6800k Manuel d'utilisateur télécharger pdf (Page 8)

7. Status Indicator Lights

(indicators vary by model)

The Status display tells you what is happening while the dishwasher is in

operation and may flash, indicating a malfunction. The lights will come ON,

indicating the sequence of the dishwasher operation.

SENSING Displayed while the ExtraClean

™

Sensor is measuring the amount of soil and

temperature of water. The dishwasher will adjust the selected cycle to achieve

optimal performance.

ADD-A-DISH Displayed during prewash indicating that dishes added now will still be

cleaned.

WASHING Displayed during prewash, main wash and rinse periods.

DRYING Displayed during HEATED DRY.

SANITIZED Displayed when cycle has met sanitization conditions.

CLEAN Displayed when a wash cycle is complete and enhancements are complete.

8. Time Remaining Display (on some models)

During operation, the display shows the minutes remaining until the cycle is complete. The

display may adjust the remaining time while the Sensing light is on. During a delay start, the

display will show hours of time remaining until the cycle starts.

9. START/RESET

START — After selecting the cycle and desired enhancements, press the START/RESET

pad to ready the dishwasher to begin the cycle. Close the door to start the

cycle or begin the DELAY START countdown. When the cycle starts, the water

fill begins and approximately 60 seconds later the wash action begins.

The dishwasher will always display your last selection and enhancements. If

you don’t want to change the settings, simply press the START/RESET pad to

ready the dishwasher and close the door to begin the cycle.

NOTE: If the START/RESET light is flashing, the cycle has been

interrupted by pressing the START/RESET pad. Light will quit flashing

after the dishwasher automatically drains out the water.

Also, if a power failure occurs NORMAL and HEATED DRY will automatically

be programmed. Make any new selections and press the START/RESET pad

to begin the new cycle.

RESET — Open the door slowly to prevent splash-out. Press the START/RESET pad

to cancel the cycle and close the door. Dishwasher will pump out and turn off

after 70 seconds.

NOTE: If the START/RESET light is flashing, close the door until the water

pumps out (this takes approximately 70 seconds) and the light stops flashing.

When the light stops flashing, the dishwasher can be reprogrammed and

restarted.

10. Clean — The CLEAN light is illuminated and a double beep will sound when the

selected cycle and enhancements are complete. You may remove the dishes

at any time. Note the high-efficiency fan will run quietly for 30 minutes to 4

hours (depending on selected cycle) after the CLEAN light is illuminated to

continue drying the dishes. This can be interrupted by opening the door and

pressing any keypad.

NOTE: To turn off the double beep indicator (or re-activate it if it was

previously disengaged), press the HEATED DRY pad 5 times within 3

seconds. A triple beep will sound to indicate the end-of-cycle beep option

has been toggled.

Dishwasher

Control Panel/Operation

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 47 48

Commentaires sur ces manuels

Pas de commentaire

GE zbd6800k Manuel d'utilisateur Page 8

Commentaires sur ces manuels

Produits connexes et manuels pour Lave-vaisselle GE zbd6800k