Ge DCVH515 Manuel d'utilisateur télécharger pdf (Page 46)

– 46 –

Test

Mode

Press Displays Exit

t01 Start/

Pause

Displays UI model number (01-16) that corresponds to the UI model

the control is currently conﬁ gured for. Always displays"---" when no

model is set in the control board. Proper model must be set when

control board replaced. Rotate knob until desired UI model number

is displayed (01-03), then press and hold Start/Pause until beep.

Press Power

Returns to t01

t02 Start/

Pause

Displays the most recent error code. Control will store 8 error codes

(E00=none). Press Start/Pause to clear each error code and display

the next. Press and hold Start/Pause to clear all error codes (will

then display E00).

Press Power

Returns to t02

t03 Start/

Pause

Displays software and non-volatile revision numbers. Presents

software revision number ﬁ rst. Press and hold Start/Pause to select

non-volatile revision number.

Press Power

Returns to t03

t04 Start/

Pause

Non-volatile memory test. The control will compute and compare

the 16-bit CRC of the non-volatile memory with the pre-computed

16-bit CRC stored in the non-volatile memory. The control will sound

the key press beep and display "EEP" after successful comparison,

or sound the invalid key beep and display "Err" if unsuccessful.

Press Power

Returns to t04

t05 Start/

Pause

Turns on all LEDs and the 7-segment display. Press Power

Returns to t05

t06 Start/

Pause

The control will sound a beep as long as any key is pressed. Press Power

Returns to t06

t07 Start/

Pause

Turns on motor and inner coil (electric) or burner (gas). Displays

outlet thermistor temperature in degrees Fahrenheit.

Press Power

Returns to t07

t08 Start/

Pause

Turns on motor and inner coil (electric) or burner (gas). Displays inlet

thermistor temperature in degrees Fahrenheit.

Press Power

Returns to t08

t09 Start/

Pause

Displays voltage read from the moisture sensor in volts. Press Power

Returns to t09

t10 Start/

Pause

Displays the condition of the exhaust system. The test takes

approximately 2 minutes to complete. The control measures

the rate of temperature increase through the inlet thermistor

for a duration of 30 seconds. An acceptable increase is 48°F

(9°C) for electric and 62°F (17°C) for gas. “LO” = exhaust too

small or restricted. “HI” = exhaust adequate. (Note: “HOT”

indicates the test was not completed normally. This test must

be initiated when the inside of the dryer is cool).

Press Power

Returns to t10

1 2 ... 41 42 43 44 45 46 47 48 49 50

Commentaires sur ces manuels

Pas de commentaire

Ge DCVH515 Manuel d'utilisateur Page 46

Commentaires sur ces manuels

Produits connexes et manuels pour Séchoirs Ge DCVH515