Ge DHDVH66 Manuel d'utilisateur télécharger pdf (Page 13)

Consumer Support

Troubleshooting TipsOperating InstructionsSafety Instructions

ge.com

STEP-BY-STEP INSTRUCTIONS (cont.)

Remove Hinge

IMPORTANT: Note the location of the hinge (left or right) before removing.

8.With the door frame part of the door laid down on a protected soft surface,

remove the hinge cover by removing the 2 tapping screws (#8) that fasten

it to the frame. The hinge cover is located at the opposite side of the hinge

assembly.

9.Remove the 2 nuts, washers and the 2 machine screws (#8).

10.Remove the hinge assembly by removing the 2 machine screws (#8) that

fasten it to the frame. Pull the hinge assembly out and set it aside.

Reinstall Hinge Assembly

11. Place the hinge assembly in the opposite side of the door. Align the hinge

holes with the door holes.

12. Loosely fasten the hinge assembly to the edge using 2 machine screws (#8).

13. Hold the door on its side with one hand and fasten the remaining 2 screws as

shown. Then tighten the 2 screws (#8) holding the hinge assembly.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 55 56

Pas de commentaire

Ge DHDVH66 Manuel d'utilisateur Page 13