Ge GFDS260GFWW Manuel d'utilisateur Page 2

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 4
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 1
Special Installation Requirements:
Stacked Installation:
Brackets for stacking dryer over washer are not included
with the washer.
Order part no. GEFLSTACK or part no. WE25X10018.
Alcove or Closet Installation:
If your dryer is approved for installation in an alcove or closet, it
will be stated on a label on the dryer back.
• The dryer MUST be exhausted to the outside.
Minimum clearances between dryer cabinet and adjacent walls
or other surfaces are: 0" either side, 3" front and rear
Minimum vertical space from floor to overhead cabinets,
ceilings, etc. is 52".
Closet doors must be louvered or otherwise ventilated and must
contain a minimum of 60 sq. in. of open area equally distributed.
If this closet contains both a washer and a dryer, doors
must contain a minimum of 120 sq. in. of open area equally
distributed.
No other fuel-burning appliance shall be installed in the same
closet with a gas dryer.
Bathroom or Bedroom Installation:
• The dryer MUST be exhausted to the outdoors.
The installation must conform with the local codes, or in the
absence of local codes, with the National Electric Code and
National Fuel Gas Code, ANSI Z223 for gas dryers.
Minimum Clearance other than Alcove or Closet Installations:
Minimum clearances to combustible surfaces 0" both sides,
3" rear.
For more information on venting kits and accessories,
please call 1-800-GE-CARES.
Specification Revised 3/14
360504
GFDS260GF/265GF
GE
®
8.1 cu. ft. capacity Front Load gas dryer with steam
Stacked Dimensions (in inches)
79-5/8
C
27-7/8
29-3/4
13
Pedestal Dimensions (in inches)
GFXP1308F
This optional 13" pedestal raises
the door opening and height of
the washer or dryer.
For answers to your Monogram,
®
Cafe
Series
or
Profile
Series appliance questions, visit
our website at geappliances.com or call GE
Answer Center
®
service, 800.626.2000.
11-5/8
3-5/8
5-3/8
1-5/8
Vue de la page 1
1 2 3 4

Commentaires sur ces manuels

Pas de commentaire