GE GFD48ESPKDG Manuel du propriétaire télécharger pdf (Page 34)

REMOVE THE DOOR ASSEMBLY

A. Open the door fully.

RE-LOCATE THE HINGE STRIKER AND

FRONT PANEL PLUGS (on some models

- see step 2B below for other models)

IMPORTANT: Note the location of the hinge (left or

right) before removing.

A. Remove 2 screws (#10 x 5/8”) and front panel

plugs from the front panel.

B. Re-install front panel plugs and screws on

opposite side of the door opening.

C. Remove 2 screws (#8 x 1/2”) and hinge striker

from the front panel.

D. Rotate hinge striker 180 degrees and re-install

with screws on the opposite side of the door

opening.

REVERSING THE DOOR SWING (if desired)

Installation Instructions

B. Remove 2 screws (#10 x 5/8”) from the hinge,

starting with the bottom screw. The door will tilt

away from the front panel, but will come to rest

in place.

C. Lift the door slightly and unhook if from the front

panel.

Place the door on a soft and flat surface.

RE-LOCATE THE HINGE STRIKER

(on some models - see step 2A above

for other models)

IMPORTANT: Note the location of the hinge (left or

right) before removing.

A. Remove 2 screws (#10 x 5/8”) from top and

bottom of door striker.

B. Remove 2 screws (#8 x 1/2”) from center of door

striker and remove door striker from front panel.

C. Rotate door striker 180 degrees and re-install

with screws on the opposite side of the door

opening.

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 143 144

Pas de commentaire

GE GFD48ESPKDG Manuel du propriétaire Page 34