GE PFDS450 Manuel d'utilisateur télécharger pdf (Page 42)

INSTALL BRACKET TO DRYER

A. Align the holes in the left bracket with the holes

in the bottom left corner of the dryer. Use a

Phillips screwdriver to install the 2 #12 x 1”

tapping screws.

B. Repeat the above step with the right bracket on

the bottom right corner of the dryer.

C. Set the dryer upright.

NOTE: Make sure to set the dryer on a piece of

packing material so the brackets that are attached

to the bottom of the dryer do not damage the floor.

INSTALL DRYER AND BRACKET ON

WASHER

A. Lift the dryer on top of the washer. Be careful

not to scratch the top of the washer with the

brackets. Protect the washer control panel with

cardboard or other protection. Be sure to lift the

dryer high enough to clear the washer control

panel.

WARNING – Potential Personal

Injury. More than two people are recommended

to lift the dryer into position because of its weight

and size. Failure to do so could result in personal

injury or death.

B. Align the holes in the bracket with the holes

in the back of the washer. Using a Phillips

screwdriver, attach the 2 #8 x 1/2” tapping

screws. Repeat on both sides of the washer

FINALIZE THE INSTALLATION

A. Refer to the washer Installation Instructions to

complete the washer installation.

B. Refer to the dryer Installation Instructions to

complete the dryer installation.

C. Carefully slide or walk the stacked washer and

dryer into place. Use felt pads or other sliding

device to assist moving and to protect flooring.

WARNING – Potential Personal

Injury. Do not push on the dryer once installed to

top of the washer. Pushing on the dryer may

result in pinched fingers.

Place

hands

here

Place

hands

here

Installation Instructions

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 155 156

Commentaires sur ces manuels

Pas de commentaire

GE PFDS450 Manuel d'utilisateur Page 42

Commentaires sur ces manuels

Produits connexes et manuels pour Sèche-linge électrique GE PFDS450