Ge 164D4290P393 Manuel d'utilisateur télécharger pdf (Page 11)

REMOVE EXHAUST ADAPTOR

If exhausting/venting using the 3

⁄4″ x 10″ rectangular

duct—optional for JV338, JV347 and JV367 models

only:

Remove the exhaust adaptor from the inside of the

hood. Set it aside along with its mounting screws.

⁄4″ x 10″

rectangular

exhaust

adaptor

and screws

REMOVE FILTER

Remove the shipping tape holding the metal grease

filter in place. Pull down on the center of the front

edge of the filter. The filter will then slip out of the

retaining tabs on the back.

REVERSE THE BAFFLE FOR

DUCTED INSTALLATIONS ONLY

(JV347 and JV367 models)

If the hood is to be recirculated, skip to the next step.

Remove the baffle from the top of the hood. Re-install

the baffle so the short side marked “VENTED” is

visible. The long side of the baffle should be inside

the hood.

REMOVE WIRING COVER

Remove the wiring cover from inside the hood.

Set the cover and its mounting screw aside.

Wiring

cover

REMOVE WIRING KNOCKOUT

Remove either the top or the back wiring knockout as

needed and install an approved strain relief clamp.

Strain relief

clamp

Metal grease filter

Installation Instructions

Back knockout

Top knockout

“VENTED” is visible

Strain relief

clamp

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 19 20

Pas de commentaire

Ge 164D4290P393 Manuel d'utilisateur Page 11