Ge JV535 Manuel d'utilisateur télécharger pdf (Page 5)

5

To clean the hood surface, use a hot,

damp cloth with a mild detergent

suitable for painted surfaces. Use a

clean, hot, damp cloth to remove soap.

Dry with a dry, clean cloth.

Do not use steel-wool pads or other

abrasive cleaners. They will scratch

the surface. Wipe with a clean, hot,

damp cloth after using cleansers.

Painted Surfaces

(on some models)

Do not use a steel-wool pad; it will

scratch the surface.

Shake bottle well.

Place a small amount of CERAMA

BRYTE

®

Stainless Steel Appliance

Cleaner on a damp cloth or damp

paper towel.

Clean a small area (approximately

8″ x 8″), rubbing with the grain of

the stainless steel if applicable.

Dry and buff with a clean, dry paper

towel or soft cloth.

Repeat as necessary.

NOTE: If a mineral oil-based stainless steel

appliance cleaner has been used before to

clean the appliance, wash the surface with

dishwashing liquid and water prior to using the

CERAMA BRYTE

®

Stainless Steel Appliance

Cleaner. After washing the surface with

dishwashing liquid and water, use a generous

amount of CERAMA BRYTE

®

Stainless Steel

Appliance Cleaner to clean the appliance.

Stainless Steel Surfaces

(on some models)

This hood requires two bulbs (not

included), maximum 50 watts.

Purchase and install PAR20, 50 W

Maximum halogen bulbs.

When replacing a bulb, let it cool first.

Make sure that power to the light has

been turned off. Never allow a hot bulb

to come into contact with water.

WARNING: To reduce the risk of

electric shock, do not connect electrical power

to the hood without both bulbs in place.

To change the light bulbs:

Grasp the bulb on the edges and

unscrew it.

Replace with the same size bulb.

CAUTION:

■ Do not touch the hood light bulbs when they

are on. They may be hot enough to cause

injury.

■ The light bulbs operate at extremely high

temperatures. If they shatter, the hot glass

could cause personal injury.

Hood Lights

NOTE: Charcoal filters are not

included with the hood. They

must be ordered from your

GE supplier.

If the model is not vented

to the outside, the air will

be recirculated through

disposable charcoal filters

that help remove smoke

and odors.

The charcoal filters should

be replaced when they

are noticeably dirty or

discolored (usually after

6–12 months, depending

on hood usage).

NOTE: DO NOT rinse, or put

charcoal filters in an automatic

dishwasher.

Charcoal Filters

(on some models)

The charcoal filters

cannot be cleaned.

They must be replaced.

For 30″ hood models, order

Kit no. WB02X11000.

For 36″ hood models, order

Kit no. WB02X11001.

These kits can be ordered

from your GE supplier.

The charcoal filters are clipped inside

of each reusable metal grease filter.

Safety Instructions

Operating Instructions Installation Instructions

Troubleshooting Tips Consumer Support

Care and cleaning of the vent hood. www.GEAppliances.com

To order:

To order CERAMA BRYTE

®

Stainless

Steel Appliance Cleaner, please call our

toll-free number:

National Parts Center. . 800.626.2002

www.GEAppliances.com

CERAMA BRYTE

®

Stainless Steel

Appliance Cleaner. . . . # PM10X311

1 2 3 4 5 6 7 8 9 10 ... 39 40

Commentaires sur ces manuels

Pas de commentaire