Ge JV965 Manuel d'utilisateur télécharger pdf (Page 11)

Installation Instructions

TOOLS AND MATERIALS

REQUIRED

(NOT SUPPLIED)

Pencil and

tape measure

Spirit level

Phillips and

Flat blade screwdrivers

Duct tape

Electric drill with

1/8″ and 3/8″ bits

1/4″ pivoting hex socket

Safety glasses

Flashlight

Saber saw or Key Hole Saw

Metal Snips

Hammer

Pliers

Additional Materials:

• 120V 60Hz. 15 or 20 Amp, 2 wire with ground.

Properly grounded branch circuit.

• Strain relief for junction box.

• 7″ round metal duct or 3-1/4″ x 12″ rectangular duct,

length to suit installation.

Wire Cutter/

Stripper

Ladder

Allen

Wrench

CAUTION: Lift hood by grasping the outside

edges of the exhaust opening on the top. Do not

lift hood by the exhaust opening divider – damage

will occur!

REMOVE THE PACKAGING

• Remove parts package from the “V” shaped cardboard

insert. Remove insert. Remove shipping pads.

• Lift the hood out of the box.

• Remove transition duct piece from the inside of the

hood. Discard screws.

• The vent hood motor is shipped secured to the skid

with 4 screws. Locate and remove 2 screws on each

side of the motor. Discard the shipping skid.

• From the inside of the hood, remove shipping screws

holding the wood mounting piece to the back side of

the hood. Set aside wood mounting piece and screws

for later installation. Do not discard.

• Remove junction box cover and knockout.

• Install strain relief onto back or top of hood.

• Remove all tape and packing material from the

hood, duct transition and motor.

Hold Down Screws

UL Listed Wire nuts

Hood

Parts

Package

Wood

Mounting

Support

Duct

Transition

Motor

Mounted

on Skid

Shipping Carton

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 23 24

Commentaires sur ces manuels

Pas de commentaire

Ge JV965 Manuel d'utilisateur Page 11

Commentaires sur ces manuels

Produits connexes et manuels pour Ventilateurs Ge JV965