Ge ZV48R Manuel d'utilisateur télécharger pdf (Page 15)

Installation Instructions

STEP 10 INSTALL IMPLEMENT

RODS

•Use a flat blade screwdriver to install stand-offs into

the bottom of the hood.

•Align implement rod to stand-offs with the screw hole

towards the inside of the hood. Secure the rod to the

stand-offs with the supplied Allen wrench.

•Follow the same procedure on the opposite side.

FINALIZE INSTALLATION

•Install the supplied infrared bulb(s).

•See the Owner’s Manual for instructions to test

operation.

Screw

Stand-offs

Into

Hood

Use Allen

Wrench to

Secure Rod

to Stand-offs

STEP 9 INSTALL SHELF “ONLY”

•Remove shelf packaging and protective film.

•If installing the shelf alone, without the backguard,

place shelf against the bottom of the hood and mark

screw hole locations “B” on the wall.

•Drill two 1/8" pilot holes.

•If drill did not enter studs, enlarge holes to 3/8".

•Insert wall anchors into enlarged holes. Remove

screws from wall anchors.

•Install two shoulder screws into holes “D” in the

bottom of hood flange leaving 1/8" gap.

•Engage shoulder screws into the keyhole slots in the

top of the shelf. Slide shelf towards the left to lock

into place.

•Install two 3/4" long machine screws through the

bottom of the shelf into the bottom hood flange,

location “E”.

1/8"

Gap

Mounting

Holes

for Shelf (B)

1 2 ... 10 11 12 13 14 15 16

Commentaires sur ces manuels

Pas de commentaire

Ge ZV48R Manuel d'utilisateur Page 15

Commentaires sur ces manuels

Produits connexes et manuels pour Ventilateurs Ge ZV48R