GE IM4D Manuel d'utilisation et d'entretien télécharger pdf (Page 21)

INSTALLING THE REFRIGERATOR

Plug in the refrigerator.

Arrange the coil of tubing

so that it does not vibrate

against the back of the

refrigerator or against the

wall. Push the refrigerator

back to the wall.

Installation Instructions

CONNECT THE TUBING

TO THE REFRIGERATOR

(CONT.)

Place the compression nut and ferrule (sleeve)

onto the end of the tubing as shown. On GE

SmartConnect

™

Refrigerator Tubing kit, the nuts

are already assembled to the tubing.

Insert the end of the tubing into the water

valve connection as far as possible. While holding

the tubing, tighten the fitting.

For plastic tubing from a GE SmartConnect

Refrigerator Tubing kit, insert the molded end

of the tubing into the refrigerator connection

and tighten compression nut until it is hand tight,

then tighten one additional turn with a wrench.

Overtightening may cause leaks.

Fasten the tubing into the clamp provided to hold

it in a vertical position. You may need to pry open

the clamp.

Tighten any connections that leak.

Reattach the compressor compartment access

cover.

TURN THE WATER ON

AT THE SHUTOFF VALVE

START THE ICEMAKER

Set the icemaker power switch to the ON position.

The icemaker will not begin to operate until it

UHDFKHVLWVRSHUDWLQJWHPSHUDWXUHRI)²&

or below. It will then begin operation automatically

if the icemaker power switch is in the ON position.

Tubing

Clamp

1/4"

Compression

Nut

SmartConnect

™

Tubing

Refrigerator

Connection

1/4" Tubing

Ferrule

(sleeve)

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 67 68

Commentaires sur ces manuels

Pas de commentaire

GE IM4D Manuel d'utilisation et d'entretien Page 21

Commentaires sur ces manuels

Produits connexes et manuels pour Réfrigérateurs GE IM4D