Ge 2-930SST Manuel d'utilisateur télécharger pdf (Page 8)

WALL MOUNT INSTALLATION

RINGER ON/OFF

1. Plug the short telephone line cord into the

PHONE LINE jack on the back of the base

and connect the other end to a wall jack.

2. Plug the power supply cord into the 9V DC

jack on the base and plug the power

supply into an AC outlet.

3. Feed the short line cord through the notch

at the top of the wall mount bracket so that

it comes through the square opening on

the bracket. Then feed the power supply

cord through both the top and bottom

notches on the bracket.

4. Attach the wall mount bracket by putting

the tabs into the slots on the top of the unit

and then snap the tabs at the bottom of the

wall mount bracket into place.

5. Slip the mounting holes over the wall plate

posts and slide the unit down firmly into

place. (Wall plate not included.)

6. Raise the base antenna.

7. Set the TONE/PULSE switch to TONE for

touch-tone service, or PULSE for rotary

service. If you don’t know which type of

service you have, check with the phone

company.

8. Select RINGER ON or OFF (on the side of

handset). When you select OFF, the

handset doesn’t ring.

9. Place handset in the base to charge for 12 hours. The CHARGE/IN USE light

comes on indicating that the battery is charging.

If you don’t charge the battery properly (for 12 hours) when you first

set up the phone, the battery’s long-term performance will be

compromised.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 31 32

Pas de commentaire

Ge 2-930SST Manuel d'utilisateur Page 8