Ge JV536HSS Manuel d'utilisateur télécharger pdf (Page 15)

TROUBLESHOOTING CHECKLIST

If the hood seems to be operating at high speed when

the control is not set on high, or if ventilation seems

LQDGHTXDWHFKHFNWKHIROORZLQJ

 Knockouts not removed from hood.

 Damper blade not opening.

 Reduced airflow because the duct is too small or the

duct length is too long.

 The duct is blocked.

 Undersized or restrictive wall or roof cap.

REPLACE WIRING COVER

Replace the wiring cover.

FOLLOW ELECTRICAL CODE

Complete the electrical wiring according to National

Electrical Code and local codes.

NOTE: This hood must be permanently grounded.

Connect house wiring (120 VAC) to hood wiring.

CONNECT WIRING

Connect house black to hood black wire, house white

to hood white wire, and house ground to hood green/

yellow wire. Securely tighten the strain relief clamp

onto the house wiring.

INSTALL LIGHT BULBS

3XUFKDVHDQGLQVWDOOWZR3$5:PD[LPXP

halogen bulbs. Light bulbs are not included with

the hood.

WARNING: To reduce the risk

of electric shock, do not connect electrical power

to the hood without both bulbs in place.

CONNECT DUCTWORK

TO HOOD

Use duct tape to make joints secure and air tight.

Duct tape

REPLACE FILTERS

The installation is complete. Turn on power at service

panel, and test for proper operation.

Installation Instructions

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 39 40

Pas de commentaire

Ge JV536HSS Manuel d'utilisateur Page 15