Ge PV970NSS Manuel d'utilisateur télécharger pdf (Page 19)

49-80549-2

INSTALL DUCT BRACKET AND

DEFLECTOR

The duct bracket should be installed against the back

ZDOODQGIOXVKZLWKWKHFHLOLQJWKHSRLQWZKHUHWKH

ceiling meets the wall should be level for the bracket

and duct cover to fit flush. This bracket will hold the

duct cover in place at the top.

Secure the bracket to the wall:

• Align the diamond centerline cutout on the bracket to

the penciled centerline on the wall.

• Mark 2 screw hole locations in the wall.

'ULOOµ

pilot holes in the marked locations.

• If pilot holes do not enter wood studs, enlarge the

KROHVWRµDQGLQVWDOOPHWDOZDOOIDVWHQHUDQFKRUV

(provided).

• If mounting directly to a masonry wall, obtain

appropriate #10 masonry screw anchors. Drill and

install per the fastener supplier’s instructions.

• Drive screws, by hand, into the fasteners to allow

DQFKRUVWRH[SDQG5HPRYHWKHVFUHZV

6HFXUHWKHEUDFNHWWRWKHZDOOZLWKZRRGVFUHZVDQG

or fasteners.

• Assemble the air deflector accessory to the

duct cover bracket with the 4 assembly screws

provided. DO NOT tighten screws. This is a temporary

installation.

Installation Instructions

INSTALL HOOD MOUNTING SCREWS

The mounting screws must enter the horizontal

support or wall studs.

• With the template taped in place, use a punch to

mark mounting bracket screw locations.

'ULOOµSLORWKROHVLQRIWKHSXQFKHGORFDWLRQVLQ

the lower bracket. If the bottom 2 pilot holes do not

HQWHUZRRGHQODUJHWKHKROHVWRµDQGLQVWDOOPHWDO

wall fastener anchors (provided).

• Remove the template.

,QVWDOOWKHWRSPRXQWLQJVFUHZVOHDYHµJDS

between the screw head and the wall. This will allow

the keyhole slot on the hood frame to engage the

screw head.

IMPORTANT: Use the mounting screws provided.

DO NOT USE DRYWALL SCREWS.

• Check to be sure the mounting screws are

horizontally level.

Centerline cutout

REAR WALL

MOUNTING TEMPLATE

Vertical Centerline

ALIGN BOTTOM EDGE

WITH PENCIL LINE

INDICATING BOTTOM

OF THE HOOD

11-7/16"

Installation Height

Horizontal Line

DRILL 2 (TWO) 3/16" PILOT HOLES THROUGH STUDS OR REAR WALL SUPPORT

10-1/8"

12-08 JR

DRILL 2 (TWO) 3/16" PILOT HOLES THROUGH STUDS OR REAR WALL SUPPORT

12-1/2"

WALL VENT IS 27-3/4" MIN.

ABOVE THE INSTALLATION

HEIGHT

31-14772 Printed in Mexico

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 51 52

Commentaires sur ces manuels

Pas de commentaire

Ge PV970NSS Manuel d'utilisateur Page 19

Commentaires sur ces manuels

Produits connexes et manuels pour Cagoules Ge PV970NSS