Ge JGRP20 Manuel d'utilisateur télécharger pdf (Page 24)

Operating Instructions Safety Instructions

Consumer Support Troubleshooting Tips

Before you call for service…

Troubleshooting Tips

Problem Possible Causes What To Do

Oven will not self-clean The oven temperature is too • Allow the oven to cool to room temperature and

high to set a self-clean operation. reset the controls.

The oven door is not fully closed. • Close door.

Oven controls improperly set. • See the Using the self-cleaning oven section.

“Crackling” or This is the sound of the • This is normal.

“popping” sound metal heating and cooling

during both the cooking and

cleaning functions.

Excessive smoking Excessive soil. • Touch the CLEAR/OFF pad. Open the windows to

rid the room of smoke. Wait until the LOCKED DOOR

light goes off. Wipe up the excess soil and reset the

clean cycle.

Oven door will not open Oven too hot. • Allow the oven to cool below locking temperature.

after a clean cycle

Oven not clean after a Oven controls improperly set. • See the Using the self-cleaning oven section.

clean cycle

Oven was heavily soiled. • Clean up heavy spillovers before starting the clean

cycle. Heavily soiled ovens may need to self-clean

again or for a longer period of time.

“LOCK DOOR” flashes The self-clean cycle has been • Close the oven door.

in the display selected but the door is not

closed.

LOCKED DOOR light The oven door is locked • Touch the CLEAR/OFF pad. Allow the oven to cool.

flashes in the display because the temperature

inside the oven has not

dropped below the

locking temperature.

“F—” and a number or You have a function error code. • Touch the CLEAR/OFF pad. Allow the oven to cool for

letter flash in the display one hour. Put the oven back into operation.

Function error code repeats. • Disconnect all power to the oven for 5 minutes

and then reconnect power. If the function error

code continues repeating, call for service.

Display goes blank A fuse in your home may be • Replace the fuse or reset the circuit breaker.

blown or the circuit

breaker tripped.

The clock is in the • See the Special features of your oven control section.

black-out mode.

Display flashes Power failure. • Reset the clock.

Unable to get the Oven control pads were • The BAKE and BROIL HI/LO pads must be touched at

display to show “SF” not touched properly. the same time and held for 2 seconds.

Power outage, Power outage or surge. • Reset the clock. If the oven was in use, you must reset

clock flashes it by touching the CLEAR/OFF pad, setting the clock

and resetting any cooking function.

1 2 ... 19 20 21 22 23 24 25 26 27 28

Commentaires sur ces manuels

Pas de commentaire

Ge JGRP20 Manuel d'utilisateur Page 24

Commentaires sur ces manuels

Produits connexes et manuels pour Four Ge JGRP20