Ge JRP14 Manuel d'utilisateur télécharger pdf (Page 25)

^Orcelain Oven Interior (lower oven only-on some models)

With proper care, the porcelain

enamel finish on the inside of

the oven—top, bottom, sides,

back and inside of the door—

will stay new-looking for years.

Let the oven cool before

cleaning. We recommend that

you wear rubber gloves when cleaning the oven.

Soap and water will normally do the job. Heavy

spattering or spillovers may require cleaning with a

mild abrasive cleaner. Soapy, wet metal pads may also

be used. Do not allow food spills with a high sugar or

acid content (such as milk, tomatoes, sauerkraut, fruit

juices or pie filling) to remain on the surface. They

may cause a dull spot even after cleaning.

Household ammonia may make the cleaning Job

easier. Place 1/2 cup in a shallow glass or pottery

container in a cold oven overnight. The ammonia

fumes will help loosen the bumed-on grease and food.

If necessary, you may use an oven cleaner.

Follow the package directions.

Cautions about using spray-on oven cleaners:

• Do not spray on the electrical controls and switches

because it could cause a short circuit and result in

sparking or fire.

• Do not allow a film from the cleaner to build up

on the temperature sensor—it could cause the oven

to heat improperly. (The sensor is located at the top

of the oven.) Carefully wipe the sensor clean after

each oven cleaning, being careful not to move the

sensor as a change in its position could affect how

the oven bakes.

• Do not spray any oven cleaner on the oven

door, handles or any exterior surface of the

oven, cabinets or painted surfaces. The cleaner

can damage these surfaces.

QTQ

Glass Window

To clean the outside of the oven window, use a glass

.eaner. Rinse and polish with a dry cloth.

Do not allow the water or cleaner to run down

inside the openings in the glass or the openings in

the top of the oven door while cleaning.

Painted Surfaces

Painted surfaces include the outside of the oven door

and the control panel. Clean these with soap and

water or a vinegar and water solution. Do not use

commercial oven cleaners, cleansing powder, steel

wool or harsh abrasives on any painted surface.

Control Panel and Knobs

It’s a good idea to wipe the control panel after each

use. Clean with mild soap and water or vinegar and

water, rinse with clean water and polish dry with a

soft cloth.

Do not use abrasive cleansers, strong liquid

cleansers, plastic scouring pads or oven cleansers

on the control panel—they will damage the finish.

A 50/50 solution of vinegar and hot water solution

works well.

The control knobs (lower oven only-on some

models) may be removed for easier cleaning.

Before removing the knobs for cleaning, please

note that the knobs on the left side and the knobs on

the right side are on the proper OFF position. When

replacing the knobs, check the OFF position to insure

proper placement.

The knob stem has a groove in each side. The groove

on one side has a spring clip. The other groove is

clear (see illustration). When removing the knob,

it may be helpful to slip a thin cloth (such as a

handkerchief) or a piece of string under and around

the knob edge and pull up. Check the inside of the

knob and find the molded rib.

Wash the knobs in soap and water or a vinegar and

hot water solution but do not soak.

Replace the knob by fitting the molded rib inside the

knob into the clear groove on the stem.

1 2 ... 20 21 22 23 24 25 26 27 28

Commentaires sur ces manuels

Pas de commentaire

Ge JRP14 Manuel d'utilisateur Page 25

Commentaires sur ces manuels

Produits connexes et manuels pour Four Ge JRP14