GE CSA1201RSS Manuel d'instructions télécharger pdf (Page 21)

Place the blower unit back into the opening.

CAUTION:Do not pull or stretch the

blower unit wiring. Make sure the wires are not

pinched.

ADAPTING BLOWER FOR

RECIRCULATION

(continued)

Replace blower plate with the screws removed in

Step 1.

Secure blower unit to oven with the screw removed

in Step 2. Insert the screw in bottom right screw

hole on the back of the oven.

Attach the oven to the top cabinet.

Cabinet Front

Cabinet Bottom Shelf

Filler Block

Oven Top

Equivalent to Depth

of Cabinet Recess

Blower Motor

Screw

Installation Instructions

Rotate front of oven up

against cabinet bottom.

MOUNT THE OVEN

FOR EASIER INSTALLATION AND PERSONAL SAFETY, WE

RECOMMEND THAT TWO PEOPLE INSTALL THIS OVEN.

IMPORTANT: Do not grip or use handle during

installation.

NOTE: If your cabinet is metal, use the nylon

grommet around the power cord hole to prevent

cutting of the cord.

NOTE: We recommend using filler blocks if the

cabinet front hangs below the cabinet bottom shelf.

IMPORTANT: If filler blocks are not used,

case damage may occur from overtightening

screws.

Insert a self-aligning screw through top center

cabinet hole. Temporarily secure the oven by

turning the screw at least two full turns after the

threads have engaged. (It will be completely tightened

later.) Be sure to keep power cord tight. Be careful

not to pinch the cord, especially when mounting

flush to bottom of cabinet.

NOTE: When mounting the

oven, thread power cord

through hole in bottom of

op cabinet. Keep it tight

throughout Steps 1–3. Do

not pinch cord or lift oven

by pulling cord.

Lift oven, tilt it forward,

and hook slots at back

bottom edge onto two

lower tabs of mounting

plate.

Self-Aligning Screw

Blower Plate Screws

Back of Oven

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 47 48

Commentaires sur ces manuels

Pas de commentaire

GE CSA1201RSS Manuel d'instructions Page 21

Commentaires sur ces manuels

Produits connexes et manuels pour Micro-ondes GE CSA1201RSS

Související produkty a manuály pro Držáky Brodit 804997