GE JNM1541SPSS Manuel d'utilisateur télécharger pdf (Page 16)

USE TOP CABINET TEMPLATE

FOR PREPARATION OF TOP

CABINET

B3.

• Read the instructions on the TOP CABINET

TEMPLATE.

• Tape it underneath the top cabinet.

• Drill the holes, following the instructions on the

TOP CABINET TEMPLATE.

CAUTION:Wear safety goggles when

drilling holes in the cabinet bottom.

Wall

Mounting

Plate

pacing for Toggles More

Than Wall Thickness

Toggle

Bolt

Toggle Wings

To use toggle bolts:

Bolt End

Installation Instructions

You need to drill holes for the top support screws and

a hole large enough for the power cord to fit through.

Place the mounting plate against the wall and

insert the toggle wings into the holes in the wall

to mount the plate.

NOTE: Before tightening toggle bolts and wood

screw, make sure the tabs on the mounting plate

touch the bottom of the cabinet when pushed flush

against the wall and that the plate is properly

centered under the cabinet.

CAUTION:Be careful to avoid

pinching fingers between the back of the mounting

plate and the wall.

Tighten all bolts. Pull the plate away from the wall

to help tighten the bolts.

BEFORE: Fan Blade

Openings Facing Up

Remove and save the screw that holds the blower

motor door closed on the back and the blower

retaining screw on the top of the door.

ADAPTING MICROWAVE

BLOWER FOR OUTSIDE

BACK EXHAUST

B4.

End B

End A

Carefully pull out the blower unit. The wires

will extend far enough to allow you to adjust the

blower unit.

Back of

Microwave

Oven

Blower Motor

Door Retaining

Screw

Blower

Open the blower door by lifting it up at the back

of the microwave oven. Remove and save the

blower retaining screw.

Blower Retaining

Screw

Blower

Retaining

Screw

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 47 48

Commentaires sur ces manuels

Pas de commentaire

GE JNM1541SPSS Manuel d'utilisateur Page 16

Commentaires sur ces manuels

Produits connexes et manuels pour Micro-ondes GE JNM1541SPSS