GE Spacemaker JVM139K Manuel d'utilisateur Page 36

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 40
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 35
THE EXHAUST FEATURE
The exhaust hood feature on your microwave oven is equipped with two
metal filters which collect grease. When the fan is operated, air is drawn
up through the filters and is then discharged through the provided venting
to the outside.
METAL
I
ME}AL
FILTER COOKTOP FILTER
LIGHT
Reusable Grease Filters
The grease filters should be cleaned at
least
once a month. Never operate your hood without the filters in place.
In situations where flaming might occur on surfaces below hood, filter
will
stop the entry of flames into the unit.
To Remove Grease Filter
To Clean and Replace Grease Filter
To remove grease filter,
To clean grease filter, soak it
and then agitate filter
grasp the “finger hold”
in solution of hot water and detergent. Don’t use
on the
filter
and slide to
ammonia or ammonia products because they will
the rear. Then pull filter
darken the metal. Light brushing can be used to
downward and to the
remove embedded dirt.
front. The filter will
drop out.
Rinse, shake and remove moisture before replacing.
To replace grease filter,
slide the filter in the frame
slot on the back of the opening.
Pull filter upward and to the front to lock into place.
Charcoal Filter Kit
(for
some models)
There is a Recirculating Charcoal Filter Kit available
Filter Kit
model
JX8
I A can be ordered from your GE
for models that are not vented to the outside.
supplier. Ask for part
WB02X9883.
GROUmmG
~STRUCTIONS
This appliance must be grounded.
In the event of an electrical short
circuit, grounding reduces the risk
of electric shock by providing an
escape wire for the electric current.
This appliance is equipped with a
power cord having a grounding
wire with a grounding plug. The
plug must be plugged into an
outlet
that is properly installed and
grounded. (Fig.
1
)
Consult a qualified electrician or
PREFERRED
METHOD
D
Q*
+
Ensure proper ground
Fig. 1
exists before use
Where a standard two-prong
wall receptacle is encountered, it
is your personal responsibility and
obligation to have it replaced with
a properly grounded three-prong
wall receptacle.
Do not under any circumstance
cut or remove the third (ground)
prong from the power cord.
Do not use an adapter plug with
this appliance.
WARNING–improper
service technician if the grounding
instructions are not completely
Do not use an extension cord
use of the grounding plug can
understood, or if doubt exists as to
with this appliance.
result in a risk of electric shock.
whether the appliance is properly
grounded.
36
Vue de la page 35
1 2 ... 31 32 33 34 35 36 37 38 39 40

Commentaires sur ces manuels

Pas de commentaire