GE JTP86 Manuel d'utilisateur télécharger pdf (Page 8)

8

(Continued on following page)

Installation Instructions

Securing the Oven in the Opening

Drilling the Pilot Holes and

Mounting the Oven

a. Drill through the mounting holes (top and

bottom) of the side trim, for the #8 screws

provided.

b. Secure the oven to cabinet with screws

provided.

NOTE: If the cabinet is particle board, you

must use #8 x 3/4” particle board screws.

These may be purchased at any hardware

store.

Sliding the Oven Into the

Opening

a. Loop (do not tie) a 36” string around the

conduit before the oven is slid into place.

This will keep the conduit from falling

behind the oven.

b. Lift oven into cabinet cutout using the oven

opening as a grip. Carefully push against

oven front frame. Do not push against

outside edges.

c. As you slide the oven back, pull the string

so that the conduit will lie on top of the

oven in a natural loop.

d. When you are sure the conduit is out of the

way, slide the oven 3/4 way back into the

opening. Remove the string by pulling on

one end of the loop.

The screws must

be a minimum of

1/4” from the front

of the cutout.

C

C1 C2

NOTE: Before drilling the pilot holes,

make sure the oven is pushed as far

back into the opening as it will go

and centered.

WARNING:

Mounting

screws must be used. Failure to

do so could result in the oven

falling out of the cabinet causing

serious injury.

Mounting Hole

Locations

Pull out on

string loop

while pushing

the oven into

the cabinet

1 2 3 4 5 6 7 8 9 10 11 12

Commentaires sur ces manuels

Pas de commentaire