Ge 164D3333P150 Manuel d'utilisateur télécharger pdf (Page 35)

Troubleshooting TipsInstallation Instructions Customer ServiceOperating InstructionsSafety Information

Power Cord Strain Relief Installation

Remove the lower rear range wiring cover to expose the connector block

and bracket.

Remove the knockout ring (1

⁄

²) located on bracket directly below the

connector. To remove the knockout, use a pair of pliers to bend the

knockout ring away from the bracket and twist until ring is removed.

Assemble the strain relief in the hole. Insert the power cord through the

strain relief and tighten. Allow enough slack to easily attach the cord

terminals to the connector block. If tabs are present at the end of the winged

strain relief, they can be removed for better fit.

NOTE: Do not install the power cord without a strain relief. The strain relief bracket should

be installed before reinstalling the rear range wiring cover.

Knockout ring in bracket. Knockout ring removed.

Wiring cover

(shown removed)

Connector box

Power cord

Ground

strap

Bracket

Strain relief bracket

(Provided with range cord. Not part of range.)

Strain relief

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 47 48

Pas de commentaire

Ge 164D3333P150 Manuel d'utilisateur Page 35