Ge 15 Manuel d'utilisateur télécharger pdf (Page 16)

Fasten the shutoff valve to the cold water pipe with

the pipe clamp.

Installation Instructions

SHUT OFF THE MAIN WATER

SUPPLY

Turn on the nearest faucet long enough to clear the

line of water.

INSTALLING THE WATER LINE

(CONT.)

Install the shutoff valve on the nearest frequently used

drinking water line.

Choose a location for the valve that is easily

accessible. It is best to connect into the side of a

vertical water pipe. When it is necessary to connect

into a horizontal water pipe, make the connection

to the top or side, rather than at the bottom,

to avoid drawing off any sediment from the

water pipe.

CHOOSE THE VALVE LOCATION

Drill a 1/4″ hole in the water pipe, using a sharp bit.

Remove any burrs resulting from drilling the hole in

the pipe.

DRILL THE HOLE FOR THE VALVE

FASTEN THE SHUTOFF VALVE

Tighten the clamp screws until the sealing washer

begins to swell.

NOTE: Do not overtighten or you may crush the

copper tubing.

TIGHTEN THE PIPE CLAMP

Pipe Clamp

Vertical Cold Water Pipe

Saddle-Type

Shutoff Valve

Washer

Inlet End

Pipe Clamp

Clamp

Screw

Route the copper tubing between the cold water

line and the refrigerator.

Route the tubing through a hole drilled in the wall

or floor (behind the refrigerator or adjacent base

cabinet) as close to the wall as possible.

NOTE: Be sure there is sufficient extra tubing

[about 8 feet (244 cm) coiled into 3 turns of about

10″ (25 cm) diameter] to allow the refrigerator to

move out from the wall after installation

ROUTE THE TUBING

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 31 32

Commentaires sur ces manuels

Pas de commentaire

Ge 15 Manuel d'utilisateur Page 16

Commentaires sur ces manuels

Produits connexes et manuels pour Réfrigérateurs Ge 15