Ge 200D26000P022 Manuel d'utilisateur télécharger pdf (Page 5)

Consumer SupportTroubleshooting TipsOperating InstructionsSafety Instructions Installation Instructions

About the temperature controls. www.GEAppliances.com

WARMERCOLDER

ADJUST REFRIGERATOR TEMP

9 IS COLDEST

WARMERCOLDER

ADJUST FREEZER TEMP

9 IS COLDEST

The temperature controls are preset in the factory at 5 for both the

refrigerator and freezer compartments. Allow 24 hours for the temperature to

stabilize to the preset recommended settings.

Several adjustments may be required. Adjust the controls one increment at a

time, and allow 24 hours after each adjustment for the refrigerator to reach

the setting you have selected.

Setting either or both controls to 0 stops cooling in both the freezer and

refrigerator compartments, but does not shut off electrical power to the

refrigerator.

Control settings will vary based on personal preferences, usage and

operating conditions and may require more than one adjustment.

NOTE: The refrigerator is shipped with protective film covering the

temperature controls. If this film was not removed during installation,

remove it now.

About TurboCool

™

(on some models).

How it Works

TurboCool rapidly cools the refrigerator

compartment in order to more quickly

cool foods. Use TurboCool when adding a

large amount of food to the refrigerator

compartment, putting away foods after they

have been sitting out at room temperature

or when putting away warm leftovers. It can

also be used if the refrigerator has been

without power for an extended period.

Once activated, the compressor will turn on

immediately and the fans will cycle on and

off at high speed as needed for eight hours.

The compressor will continue to run until

the refrigerator compartment cools to

approximately 34°F (1°C), then it will cycle

on and off to maintain this setting. After 8

hours, or if TurboCool is pressed again, the

refrigerator compartment will return to

the original setting.

How to Use

Press TurboCool. The TurboCool

indicator light will come on; however,

the refrigerator temperature display

will still show the current setting.

After TurboCool is complete, the TurboCool

indicator light will go out.

NOTES: The refrigerator temperature

cannot be changed during

TurboCool.

The freezer temperature is not

affected during TurboCool.

When opening the refrigerator

door during TurboCool, the fans

will continue to run if they have

cycled on.

1 2 3 4 5 6 7 8 9 10 ... 39 40

Commentaires sur ces manuels

Pas de commentaire

Ge 200D26000P022 Manuel d'utilisateur Page 5

Commentaires sur ces manuels

Produits connexes et manuels pour Réfrigérateurs Ge 200D26000P022