Ge GBC12IAX Manuel d'utilisateur télécharger pdf (Page 13)

13

Installation Instructions

HANG THE FREEZER DOOR

Using a thin-blade screwdriver, pry the center

hinge plug from the cabinet. Be careful not to

scratch the surface.

Install the center hinge plug on the right side

of the cabinet where the hinge bracket was

removed.

Make sure the washer(s) are in place

on the bottom hinge pin. Place the freezer door

on the bottom hinge.

Close the door and tape it in place with

masking tape.

8

A

B

C

D

INSTALL CENTER HINGE

Insert the pin on the bottom of the center hinge

into the freezer door on the left side with the

back of the bracket against the cabinet. The

hinge bracket will have to be inverted for this

installation. Using screws previously removed,

attach the hinge to the cabinet.

Remove the tape holding the door shut.

CAUTION: When assembled correctly,

the hinge is tight against the cabinet.

ATTENTION: Screws must be properly tightened.

Turn the screws until snug. Then tighten the screws

a minimum of 1/2 turn using both hands.

9

A

B

TRANSFER FRESH FOOD DOOR

HANDLE

Using a thin-blade screwdriver, carefully

remove the square button plugs from the

handle. NOTE: Be careful not to scratch

the stainless steel or plastic surfaces.

Remove the round button plugs on the other

side of the door. NOTE: Be careful not to scratch

the stainless steel surface.

Using a Phillips screwdriver, remove the screws

from the handle.

Insert the round button plugs into holes

on the hinge side of the door. NOTE: Be careful

not to scratch stainless steel.

Place the door handle over the holes

on the handle side of the door. Attach

using the screws removed earlier.

Insert the square button plugs over the handle

screws. NOTE: Be careful not to scratch

stainless steel or plastic surfaces.

10

A

B

C

D

E

F

Center Hinge Plug

Square

Button

Plugs

Round

Button

Plugs

Phillips

Screws

Screws

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 67 68

Commentaires sur ces manuels

Pas de commentaire