Ge ZDIS150ZSS Manuel d'utilisateur Page 15

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 18
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 14
Installation Instructions for ZIP75BB Kit
15
NOTE: If installing a 3/4” trimless custom panel,
a 1-1/2” wide filler strip may be required. The filler
strip will act as a spacer between the ice maker
case and the adjacent cabinet, and will prevent
interference with the ice maker door swing when
it is installed between frameless or framed
cabinetry. The width of the cutout opening must
include the width of the filler strip. The product
cannot be installed flush to adjacent 24 deep
cabinets with a 3/4” thick custom panel.
This kit contains a new handle and two side
mounting brackets to support a trimless custom
door panel up to 3/4” thick. A custom handle
may replace the supplied handle.
IMPORTANT:
&XWHGJHVRIWKHFXVWRPGRRUSDQHOZLOOEH
seen and must be finished for best ap pear ance.
The back side of the panel should be finished a
minimum of 1/2” on all sides.
7KHFXVWRPSDQHOERWKUDLVHGDQGIODWGHVLJQ
should be con struct ed in the same manner
as typical cabinet doors.
2UGHUWKHFXVWRPSDQHOIURPWKHFDELQHW
manufactur er. Be sure to provide the exact
dimensions so that the panel is con struct ed
accurately.
 BEFORE YOU BEGIN:
Read these instructions completely and carefully.

IMPORTANT:
Save these instructions for local inspector’s use.

IMPORTANT:
Observe all governing codes and ordinances.
 1RWHWR,QVWDOOHU²Be sure to leave these
instructions with the Consumer.
 1RWHWR&RQVXPHU²Keep these instructions
with your Owner’s Manual for future reference.
WARNING:
Disconnect electrical power supply to ice maker
before installing front panel. Failure to do so can
result in death, fire, or electrical shock. Do not
operate ice maker while installing panel.
AVERTISSEMENT :
Il faut debrancher l’alimentation de la machine
à glaçons avant d’installer le panneau avant.
Le non-respect de ces instructions peut causer
la mort, un incendie ou un choc électrique. N’utilisez
pas la machine à glaçons pendant l’installation du
panneau.
Kit Contents:
VLGHWULPSLHFHV
VLGHWULPVFUHZV
'RRUKDQGOH
Tools and Materials Required:
IODWKHDGZRRGVFUHZV” long
'ULOODQG” bit
6DIHW\JODVVHV
7DSH
&XVWRPSDQHO
Vue de la page 14
1 2 ... 10 11 12 13 14 15 16 17 18

Commentaires sur ces manuels

Pas de commentaire