Ge 20622 GE Universal Remote Manuel d'utilisateur télécharger pdf (Page 7)

Code Search

If your device does not respond after you have tried all the codes

for your brand, or if your brand is not listed, try searching for your

code by following these steps.

1. Manually turn on the device (TV, DVR, etc.) to be

controlled.

2. Press and hold the SETUP button until the red

indicator stays on, then release the SETUP button.

3. Press and quickly release the desired device button

(TV, DVR, etc.). The red indicator blinks off once.

4. Press the ON•OFF button repeatedly (up to 300 times)

until the device to be controlled turns off. The red

indicator blinks off with each button press.

5. Press and release ENTER to install the code.

Most users will store VCR codes under the VCR button,

Cable codes under CABLE, etc. If (for example) you want to

store a VCR code under CABLE, ﬁrst follow the procedure for Direct

Code Entry (previous page) and press CABLE in step 2 of Direct

Code Entry, then enter ANY VCR code in step 3 of Direct Code Entry.

Then follow the steps above for Code Search.

Note: Code Search starts from the currently stored four digit

number under that mode. Sometimes the ﬁrst code that “works”

with your device may only allow limited functionality (e.g. the MENU

button might not work). There may be a code that performs more

functions. Continue the code search process until the best code is

found.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15

Pas de commentaire

Ge 20622 GE Universal Remote Manuel d'utilisateur Page 7