Ge 24988 GE Infrared Signal Remote Extender Manuel d'utilisateur télécharger pdf (Page 4)

Before installing the emitter and IR receiver, thoroughly clean the surface.

A. Standard and Preferred installation

1. The preferred method is to attach

the IR emitters directly to the IR

sensor window on electronic device.

2. To locate the IR sensor on your

electronic device, you may have to

use a ﬂashlight to shine into the front of the component through the glass

to ﬁnd the sensor. The sensor may be a square or round circle

depending on the manufacturer of the electronic device.

(See illustration for an image of a sensor.)

3. Once found, peel the adhesive sticker off the emitter and press ﬁrmly onto

the front of the component over the IR sensor. Do not press too hard to break

the front of the component. Please note that the surface must be clean and

dry as well as a ﬂat surface the emitter to adhere properly. The emitter will

not adhere to curved surfaces.

B. Attach emitter on inside shelf

1. Attach emitter on shelf above or below IR

sensor.

2. Press the emitter ﬁrmly on the shelf as

close as possible to the IR sensor.

The will ﬂood the area of infrared

signal for the component to receive.

1 2 3 4 5 6 7

Pas de commentaire

Ge 24988 GE Infrared Signal Remote Extender Manuel d'utilisateur Page 4