Ge ZGU484NGPSS Manuel d'utilisateur télécharger pdf (Page 15)

TOOLS YOU NEEDED FOR CONVERSION

CONVERT THE REGULATOR

Disconnect all electrical power at the main circuit

breaker or fuse box.

A. Remove the rear vent

trim (on ranges only) to

access the regulator.

The Rangetop

regulator is on the left bottom corner.

B. Shut off the gas supply by closing the manual shut-off

valve in the unit or at the wall.

Convert the pressure regulator:

• Unscrew the cap with plunger.

• Place your thumb against flat side of the plunger and

press down to snap the plunger out of the cap.

• Carefully look at the

plunger to locate the

NAT or LP position.

• Turn the plunger over

so that the desired

gas is showing near

the bottom.

• Snap the plunger

back into the cap.

• Screw the cap back

onto the regulator.

CHANGE BURNER ORIFICES

INSTALLATION TIP: First remove all

orifices and then start replacing them.

This will help to prevent the possibility

that some may not be replaced.

A. Remove the burner grates,

burner caps and burner heads.

B. Loosen the top burner

orifices using a 7 mm nut

driver. Use small pliers to

carefully lift out the orifices.

The main orifice is

located low in the

center of the burner,

while the simmer

orifice is located

higher beside the

center of the burner.

DOWN

FOR OFF

NAT

Gasket

Cap

Plunger

LP Position

NAT.

Position

Pressure Regulator

Burner Cap

Burner

Head

Spark

Igniter

Main

Orifice

Simmer

Orifice

WARNING: This conversion must be

performed by a qualified installer or gas supplier in

accordance with the manufacturer’s instructions and

all codes and requirements of the authority having

jurisdiction. Failure to follow instructions could result in

serious injury or property damage. The qualified agency

performing this work assumes responsibility for the

conversion.

WARNING: The rangetop, as shipped from

the factory, is set for use with its intended gas. If you

wish to use your rangetop with the alternate gas, you

must first replace the orifices and convert the pressure

regulator.

WARNING: The following adjustments

must be made before turning on the burner. Failure to

do so could result in serious injury. Be sure pressure

regulator has been converted as described in Step 2.

Safety Glasses

Small Flat-Head Screwdriver

(2 to 2.4 mm or 3/32” tip size,

60 mm long)

Crescent Wrench

1/4” and 7mm

Nutdrivers

Installation Convert Natural Gas to LP Gas Operation

Instructions Convert LP Gas to Natural Gas Operation

Small Pliers

1/2” Deepwell

Socket Wrench

Philips

Screwdriver

ORIFICE HOLDER

The range orifice holder is

located behind the front

access panel at the bottom

of the range.

The rangetop orifice holder

is located inside the range insulation cover.

Additional orifices may be present. Use only the orifices

specified in the instructions for your range or rangetop.

Burner Base

Griddle

Orifice

Grill

Orifice

Burner Orifices

Range Regulator

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 51 52

Commentaires sur ces manuels

Pas de commentaire

Ge ZGU484NGPSS Manuel d'utilisateur Page 15

Commentaires sur ces manuels

Produits connexes et manuels pour Poêles Ge ZGU484NGPSS