GE ALM1 Guide d'installation télécharger pdf (Page 2)

4 5

Before installation, loosen two screws on side of xture,

and open by holding lenses and sliding LED plate away

from screws.

Remove appropriate knockout in xture for power input. Install box to intended surface using mounting holes

on both ends of xture with appropriate mounting

hardware. If mounting into a joist, use 2 wood screws

and 2 washers to attach to joist. If joist is not available,

use 2 toggle bolts and 2 washers to attach to plasterboard.

Remove red wire and blue wire which lead to the power

supply from connectors, and remove LED plate from box

by rotating LED plate 90° and sliding the plate towards

the box until the hinges can be removed.

For safety, turn off main power prior to installation.

Unit Installation

6 7

Connect the black (line) and white (neutral) wires of the

AC line to the similarly colored wires of the xture’s LED

driver using UL listed wire connectors. Connect the green

(ground) to the lug inside the xture.

Reinsert the LED plate into the box so that it is hanging

open by the hinges.

AC line

Fasten to ceiling with appropriate hardware

Remove LED plate

LED driver

1 2 3

Pas de commentaire

GE ALM1 Guide d'installation Page 2