GE BR Series Guide d'installation

Naviguer en ligne ou télécharger Guide d'installation pour Non GE BR Series. GE BR Series Installation Guide Manuel d'utilisatio

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 4
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 0
GE
Lighting
Installation Guide
imagination at work
For Backlit Recessed Troffer Luminaires
Driver Replacement
BEFORE YOU BEGIN
Read these instructions completely and carefully.
WARNING/AVERTISSEMENT
RISK OF ELECTRIC SHOCK
• Turn power off before inspection, installation or removal.
• Properly ground electrical enclosure.
RISK OF FIRE
• Follow all NEC and local codes.
• Use only UL approved wire for input/output connections.
Minimum size 18 AWG (0.75mm
2
).
RISQUES DE DÉCHARGES ÉLECTRIQUES
• Coupez l’alimentation avant d’’inspecter, installer ou déplacer le luminaire.
Assurez-vous de correctement mettre à la terre le boîtier d’alimentation électrique.
RISQUES D’INCENDIE
• Respectez tous les codes NEC et codes locaux.
• N’utilisez que des ls approuvés par UL pour les entrées/sorties de
connexion. Taille minimum 18 AWG (0.75mm
2
).
Prepare Electrical Wiring
Electrical Requirements
• The LED driver must be supplied with 120-277 VAC or
347VAC, 50/60 Hz and connected to an individual properly
grounded branch circuit, protected by a 20 ampere circuit
breaker. Use min. 75°C supply conductor.
Grounding Instructions
The grounding and bonding of the overall system shall
be done in accordance with National Electric Code (NEC)
Article 600 and local codes.
Components Supplied
• Driver of luminaire
Tools and Components Required
• T15 torx screwdriver
• UL listed conduit connections per NEC/CEC for nominal
conduit trades sizes ½” or ¾”
• UL recognized wire connectors
Save These Instructions
Use only in the manner intended by the manufacturer.
If you have any questions, contact the manufacturer.
Specications
Description Code Corresponding Luminaires
Backlit Troffer 22 and 14 driver (1-10V dimming) Backlit Troffer 22 and 14 Series
Backlit Troffer 24 driver (1-10V dimming) Backlit Troffer 24 Series
Vue de la page 0
1 2 3 4

Résumé du contenu

Page 1 - Driver Replacement

GELightingInstallation Guideimagination at workFor Backlit Recessed Troffer LuminairesDriver ReplacementBEFORE YOU BEGINRead these instructions comple

Page 2 - Wiring Diagrams

Wiring DiagramsPSU(1-10V) +(1-10V) –+–Light Engine+–LineNeutralRemote Switch 1-10V (Optional)VIOLETGREYREDBLUEBLACKWHITE(1-10V) –(1-10V) +GNDNL1-10V D

Page 3 - Driver Replacement Steps

1 2Rotate latches to unlock the front bezel. Swing down panel and lift off front bezel.Driver Replacement StepsFor Backlit Troffer 22 and 24: unfasten

Page 4 - IND125-081414

87Rotate latches to lock the front bezel.Hang panel on its hinges and swing up into place. This device complies with Part 15 of the FCC Rules. Operati

Commentaires sur ces manuels

Pas de commentaire