GE D Guide d'installation télécharger pdf (Page 2)

INSTALLATION

1.A. For Nuvation

™

with Dimming Option, remove both wiring box

doors (Figure 2) for electrical connections and box removal.

2. Thread the Wiring Box onto the conduit. Secure the conduit

with the set screw provided. Ensure that the Wire Box cannot

turn on the conduit once Set Screw has been tightened.

SET

COVER SCREWS

CONDUIT (NOT SUPPLIED)

THREADED

BOSS

WIRING BOX

END COVER

WIRING BOX

Figure 1

Figure 2

THREADED

BOSS

WIRE BOX SLIDE

MOUNTING

BRACKET

Figure 3

WIRING BOX

WET LOCATION OPTION

When installing in a wet location, it is important to properly install

the Conduit with an appropriate water sealing material. The GE

Lighting Systems wet location wiring box and a GE Lighting

Systems wet location optical must be used.

WIRING

Make all electrical connections in accordance with the -National

Electrical Code and any applicable local code requirements.

Verify that the supply voltage is correct by comparing it to the

ballast’s “luminaire fitting” nameplate.

Figure 4 Figure 5

3. Slide the Wiring Box onto the Mounting Bracket, which is

preassembled on to the Upper Housing as shown in

Figure 3.

NOTE: The Ballast Housing is not fully secure until the wire box

End Covers are reattached!

4. Connect the supply wires from mains to the Black and White

supply leads. Connect the Green Earth Ground Lead. Adhere

to the requirements defined the WIRING section below.

5. Replace the Wire Box End Covers. Insert and securely

retighten the End Cover Screws as shown in Figure 2.

The Ballast Housing is now secure.

FLEXIBLE MOUNTING

If flexible mounting accessories (hook or loop) are supplied

separately, thread the shaft into hanger hub/locking nut

assembly and follow the instructions above for conduit mounting.

CAUTION: If this instruction is not followed damage to the

mounting parts can occur causing the fixture to fall. When

using hook or loop fixture mounting, do not apply luminaire

weight when the mating parts are as shown in Figure 4. Do not

apply any twisting action to the hook and loop assembly. When

properly installed the hook and loop assembly is as shown in

Figure 5.

CONDUIT MOUNTING

1. Remove the Wire Box End Cover by removing the two (2)

screws as shown in Figure 1.

WARNING

Risk of fire

• Keep combustible materials away

from lens

• Use lamps specified on the

“luminaire fitting” nameplate

• Maintain a minimum of 3 feet

clearance below the luminaire

CAUTION

Unit will fall if not installed properly

• Follow installation instructions

• Attach ONLY by threaded Boss

• Do not use Knockout Holes for

mounting.

1 2 3 4

Commentaires sur ces manuels

Pas de commentaire

GE D Guide d'installation Page 2

Commentaires sur ces manuels

Produits connexes et manuels pour Non GE D