GE EASB Guide d'installation

Naviguer en ligne ou télécharger Guide d'installation pour Non GE EASB. GE EASB Installation Guide Manuel d'utilisatio

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 12
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 0
Scalable Fixture (EAS)
Evolve
LED Area Light
BEFORE YOU BEGIN
Read these instructions completely and
carefully.
Save these instructions for future use.
This luminaire is designed for outdoor lighting service,
and should not be used in areas of limited ventilation,
or in high ambient temperatures.
Best results will be obtained if installed and maintained
according to the following recommendations.
Luminaire is designed to operate in ambient
temperatures ranging from -40°C to 50°C
(-40°C to 35°C for >400W) and to be mounted
horizontally to a vertical pole with LEDs facing down,
or aimed up to 45° upward with a Knuckle slip fitter.
WARNING
Risk of electrical shock. Disconnect power before servicing
or installing product.
GE
Lighting
Installation Guide
GEH-6016B
imagination at work
SPECIFICATIONS
Weight: Maximum weight <50 lbs (22.68 kg)
EPA: Horizontal mounting: 0.97 sq ft max (0.09 sq M)
45° mounting: 1.97 sq ft max (0.18 sq M)
IP Rating: Optical 65, Standard Electrical Enclosure:
UL 1598 Wet Location Rated
CAUTION
Risk of injury. Wear safety glasses and gloves during
installation and servicing.
WARNING
Risk of injury or damage. Unit will fall if not installed
properly. Follow installation instructions.
This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) This device may not cause
harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
This Class [A] RFLD complies with the Canadian standard ICES-003.
Ce DEFR de la classe [ A ] est conforme à la NMB-003 du Canada.
Note: This equipment has been tested and found to comply with the
limits for a Class A digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference when the equipment is operated in a commercial
environment. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with
the instruction manual, may cause harmful interference to radio
communications. Operation of this equipment in a residential area
is likely to cause harmful interference in which case the user will be
required to correct the interference at his own expense.
Vue de la page 0
1 2 3 4 5 6 ... 11 12

Résumé du contenu

Page 1

Scalable Fixture (EAS)Evolve™ LED Area LightBEFORE YOU BEGINRead these instructions completely and carefully.Save these instructions for future use.•

Page 2 - UNPACKING

ADVERTENCIABajo ninguna circunstancia se deberá apretar los tornillos con un nivel de torque mayor a 14 libras por pie (19 N-m).3b Montaje con Brazo

Page 3 - (76mm) OD Tenon

• NOTA: Todas las conexiones eléctricas deberán realizarse de acuerdo con el Código Eléctrico Nacional y conforme a códigos locales correspondientes

Page 4 - MAINTENANCE / CLEANING

Conexiones de Placa Terminal:Posición de Placa Terminal Tipo de Suministro L1 Línea Alta G Puesta a Tierra N/L2 Línea Baja/Neutro• NOTA: Veri

Page 5 - Guide d’installation

3b Round Pole Architectural Arm MountingThis luminaire has been configured specifically to mount to round pole 3.5-4.5 inches (89-114mm) in diameter.

Page 6 - DÉBALLAGE

3c Square Pole Architectural Arm MountingThis luminaire has been configured the same as 3b and an adapter plate has been included to mount to a squar

Page 7 - poteau carré

• Prior to installation, units should NOT be stored outside in corrugated boxes (cardboard boxes) alone.• Until installation, all units should

Page 8 - ENTRETIEN ET NETTOYAGE

Appareil d’éclairage évolutif (EAS)Luminaire de zone à DEL Evolve™AVANT DE COMMENCERLisez attentivement toutes ces instructions. Conservez ces instruc

Page 9 - Lámpara de Área Evolve

AVERTISSEMENTLes boulons du joint coulissant ne doivent jamais être serrés avec un couple dépassant 14 lb pi (19 Nm).3b Montage avec bras architectu

Page 10 - DESEMPAQUE

• REMARQUE: Toutes les connexions doivent être conformes aux normes électriques nationales et à la réglementation locale en vigueur (code élect

Page 11 - CABLEADO

• Avant leur installation, les luminaires ne doivent PAS être entreposés à l’extérieur dans de simples boîtes en carton.• Jusqu’à leur installatio

Page 12 - MANTENIMIENTO/LIMPIEZA

Lámpara Escalable (EAS, por sus siglas en inglés) Lámpara de Área Evolve™ LED ANTES DE EMPEZARLea estas instrucciones por completo y detenidamente. Gu

Commentaires sur ces manuels

Pas de commentaire