GE WPGT9350 Manuel d'utilisateur télécharger pdf (Page 23)

Installation Instructions

LEVEL THE WASHER

Move the washer into final position.

• To check if the washer is level side to side,

open the lid and place a level at the back of

the opening above the dispenser drawer.

• To check if the washer is level front to back,

place a level at the side of the washer on

the edge where the cabinet side meets the

top cover.

If the washer is not level, adjust the front

leveling legs. Turn clockwise to raise,

counterclockwise to lower.

SET REAR LEGS

Remove the level and tilt the washer forward

(pivot on front legs) about 4 to 6 inches and

gently lower the rear legs back onto the floor.

This action will set rear leg adjustments to

correspond to front settings.

ATTACH SERIAL CABLE FOR

WASHER/DRYER

COMMUNICATION

(if desired)

Attach the serial cable shipped with the dryer

for washer/dryer communication to the serial

port on the back of the washer.

Serial Port

Lower

Raise

Rear of Washer

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 67 68

Pas de commentaire

GE WPGT9350 Manuel d'utilisateur Page 23