GE DECT 28821 Manuel d'utilisateur télécharger pdf (Page 24)



6. The receiving handset will turn on the microphone and the originating handset

will turn on the speakerphone to monitor sound from the receiving handset.

NOTE: For room monitoring mode to work, the originating handset

must NOT be on the cradle.

NOTE: While in room monitoring mode, the handsets will emit an

alert tone approximately every 5 seconds if there is an incoming

call. You may press the SPEAKER button to quit room monitor and

answer the call.

NOTE: While in room monitoring mode, the originating handset can be

switched to monitor by handset earpiece by pressing the TALK button once.

Switch back to speakerphone by pressing the SPEAKER button once.

NOTE: Press the END/cancel button on the handset to exit room

monitor mode.

Answerer

In the Answerer Menu, there are two programmable submenus: Set Alarm Clock and

Handset Setup.

1. Make sure your phone is

OFF (not in TALK mode).

. Press the mute/menu OK button to go to the main menu.

. Press CALLER ID-VOLUME (

5 or 6) button to scroll to ANSWERER.

. Press mute/menu OK button to enter the submenu.

Set Alarm Clock

1. Make sure your phone is OFF (not in TALK mode).

. Press the mute/menu OK button to go to the main menu.

. Press CALLER ID-VOLUME (

6 or 5) button to scroll to ALARM.

. Press mute/menu OK button to enter the submenu,

ALARM 1ON 2OFF shows on

the display.

5. Use the touch-tone pad to enter the selection, or use the CALLER ID-VOLUME

( 6 or 5) button to scroll to 1ON or 2OFF.

6. If you select

ON, press the mute/menu OK button to conrm and advance Set

Alarm Time sub-menu.

7. Use the number keys to enter the time, then press the #/pause button to toggle

between AM and PM.

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 59 60

Pas de commentaire

GE DECT 28821 Manuel d'utilisateur Page 24