GE JB250DFBB Manuel du propriétaire télécharger pdf (Page 17)

49-80700

Be sure the controls are turned to OFF and the surface units are cool before attempting to remove them.

CARE AND CLEANING: Cleaning the Range – Exterior

Cleaning the Range – Exterior (Cont.)

Surface Units

To clean the surface units, turn the control to the highest

setting for a minute. The coils will burn off any soil.

To remove a surface unit:

To remove the drip pans for cleaning, the surface units

must be removed first.

1. Push the surface unit back toward the receptacle to

free the locking tab from the cooktop.

2. Lift the surface unit about 1 inch above the drip pan

and pull it out.

Do not lift the surface unit more than 1 inch. If you do, it

may not lie flat on the drip pan when you plug it back in.

NOTE: Repeated lifting of the surface unit more than 1

inch above the drip pan can permanently damage the

receptacle.

To replace a surface unit:

1. Replace the drip pan into the recess in the cooktop.

Make sure the opening in the pan lines up with the

receptacle.

2. Insert the terminals of the surface unit through the

opening in the drip pan and into the receptacle.

3. Push the surface unit in and down to lock the tab in

place so it rests evenly in the cooktop.

Do not immerse the surface units in liquids of any kind.

Do not clean the surface units in a dishwasher.

Do not bend the surface unit plug terminals.

Do not attempt to clean, adjust or in any way repair the

plug-in receptacle.

Drip Pans

Remove the surface units. Then lift out the drip pans.

For best results, clean the drip pans by hand. Place

WKHPLQDFRYHUHGFRQWDLQHURUDSODVWLFEDJZLWK»

cup ammonia to loosen the soil. Rinse with clean water

and polish with a clean soft cloth.

The drip pans may also be cleaned in a dishwasher.

Clean the area under the drip pans often. Built-up soil,

especially grease, may catch fire.

Do not cover the drip pans with foil. Using foil so close to

the receptacle could cause shock, fire or damage to the

range.

NOTE: If your cooktop is equipped with shiny, silver-

colored drip pans, do not clean them in the self-cleaning

oven. Permanent damage to the finish can occur.

If your cooktop is equipped with black or gray porcelain-

coated drip pans, they can be cleaned in the oven during

the self-cleaning cycle. Before you begin a self-cleaning

cycle, remove any heavy soil from the drip pans and

place them on the porcelain-coated oven racks. Do not

place the drip pans directly on the oven bottom. After

the self-cleaning cycle is completed and the drip pans

are cool, wipe them with a damp cloth to remove any

remaining ash or residue.

Lift-Up Cooktop

The entire cooktop may be lifted up and supported in the

up position for easier cleaning.

The surface units do not need to be removed; however,

you may remove one to make raising the cooktop easier.

There are two side supports that lock into position when

the cooktop is lifted up.

After cleaning under the cooktop with hot, mild soapy

water and a clean cloth, lower

the cooktop. Be careful not to

pinch your fingers.

To lower the cooktop, push the

rods back and gently lower the

cooktop until it rests in place.

When properly seated, the locking tab

should lock onto the cooktop rim through

the notch in the drip pan.

Locking Tab

Cooktop Rim

Drip pan

Surface unit

Receptacle

Drip Pan

Locking

Tab

Surface Unit

Locking Tab

Be sure all surface units

are turned off before

raising the Cooktop.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 23 24

Commentaires sur ces manuels

Pas de commentaire

GE JB250DFBB Manuel du propriétaire Page 17

Commentaires sur ces manuels

Produits connexes et manuels pour Cuisiniers GE JB250DFBB