Ge JVB65 Manuel d'utilisateur télécharger pdf (Page 11)

Adjust the Switch

The downdraft is factory-adjusted for proper

operation. However, shipping and handling may

affect the positions of the activating switch.

To adjust position of activating switch:

1. If the downdraft is plugged into the electrical

outlet, unplug it.

2. Lift the air vent straight up and cock it slightly

so it remains in the UP position.

3. Remove the switch cover from the right end

of the air vent.

4. Loosen the 2 screws holding the switch

bracket in place. Position the switch bracket so

that the activating switch just comes in contact

with the underside of the switch membrane.

Tighten the screws.

5. Replace the switch cover, gently lower the

air vent into the chimney, and plug in the power

cord. Re-connect the electrical power and check

operation.

WARNING: To avoid possible electrical

shock, personal injury or death—

disconnect electrical power.

Install the Cooktop

1. Align the cooktop with the downdraft and

fasten cooktop in place.

NOTE: Accurate alignment of cooktop and

downdraft is necessary to ensure that there is

not interference when air vent is raised and

lowered. There should be a gap of 1/32″–1/16″

between the back of the cooktop and the front of

the downdraft cover.

Switch

bracket

Switch

cover

Screws

Switch membrane

1 2 ... 6 7 8 9 10 11 12

Pas de commentaire

Ge JVB65 Manuel d'utilisateur Page 11