Ge MONOGRAM ZV1050 Manuel d'utilisateur Page 13

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 16
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 12
13
Installation Instructions
STEP 8 INSTALL DECORATIVE DUCT COVERS
Pretapordrivedecorativescrewintothescrew
holes on the support frame. This will make screw
installation easier.
Separate the two decorative duct covers.
Select the inside cover (top), which has two screw
holes in the top.
Slide the decorative duct cover over the support frame
and push to the ceiling.
Attach to the hood support at the top with 2 supplied
decorative screws.
Locate the third decorative screw in the hardware
package. Set aside.
Slide the lower decorative duct over the installed upper
duct and push to the top, keeping the bottom slotted
hole to the left.
Install the decorative stop screw in the center hole of
the upper (inner) duct cover. The decorative screw will
act as a stop screw and prevent the lower decorative
duct cover from sliding down.
CAUTION: The stop screw must be
installed. Failure to do so could result in personal injury
or damage to the duct cover.
PRUDENCE : La vis supérieure
doit être en place, afin d’éviter les blessures ou
d’endommager le capot antipoussière.
STEP 9 INSTALL HOOD
NOTE: AT LEAST THREE PEOPLE ARE REQUIRED
TOCOMPLETETHISINSTALLATION!
Lift the hood up to the support frame. Carefully align
the hood mounting holes to the support frame holes
and, at the same time, the hood duct connector into
the duct.
Install screws through the hood and hood support.
Check hood level in both directions.
Check to be sure that the duct is positioned over the
hood connector.
Seal the duct connection with duct tape.
NOTE: Do not drive screws through this duct
connection. Doing so will prevent proper damper
operation.
Stop Screw
Apply Duct Tape
to Seal Duct
Connection
Install
4 Lock Washers
and 4 Machine Bolts
Bottom
Duct
Cover
538Dia23
Vue de la page 12
1 2 ... 8 9 10 11 12 13 14 15 16

Commentaires sur ces manuels

Pas de commentaire