Ge PV977NSS Manuel d'utilisateur télécharger pdf (Page 25)

49-80550-2

Installation Instructions

STEP 11 INSTALL DUCT COVERS

IMPORTANT: Two people are required to install

the duct covers.

NOTE: If you are installing this hood for recirculating

operation, place the duct covers onto the hood with

the venting slots at the top. If the hood is vented to

the outside, the holes should be positioned on the

bottom.

• Remove the protective film from all duct covers.

• Place one upper duct cover over the rear of the

support assembly. The tabs on the edges of the

duct cover will slide into a notch on the duct cover

support. When all 6 tabs on the duct cover are in the

notches on both of the duct cover supports, slide the

duct cover up so it sits on the duct cover support

spring clip.

Left duct

cover

Duct cover

support spring

clip

STEP 11 INSTALL DUCT COVERS (cont.)

• Place a duct cover clip onto the bottom of the

rear lower duct cover locking the clip into place.

Repeat on the other side.

• Lower the duct cover into the recess on the hood.

• Place the front lower duct cover into the recess of

the hood locking it onto the duct cover clip on the

rear cover.

• Place a duct cover clip on each side where the

front and rear duct covers meet. This will hold the

rear and front covers together.

Duct cover clip

• Using screws provided, secure the lower duct

covers to the hood assembly from the underside

of the hood.

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 59 60

Pas de commentaire

Ge PV977NSS Manuel d'utilisateur Page 25