Ge 49-8779 Manuel d'utilisateur télécharger pdf (Page 51)

Troubleshooting TipsInstallation Instructions Customer ServiceOperating InstructionsSafety Information

4-Wire Conduit Installation

Remove the 3 screws from the connector block. Remove the grounding strap

from the connector block middle location and the screw connecting it to the

frame of the range. Insert bare wires between the connector block terminals

and movable nuts. Tighten screws securely. Attach ground wire to the frame of

the range.

WARNING: Connector block is approved for copper wire connection

only. If aluminum wire is used, see note below.

NOTE: ALUMINUM WIRING

Do not connect aluminum wire to connector block.

Use copper building wire rated for the correct amperage and voltage to

make 3 (three) 3″ copper jumper wires. Connect wire as per Step 6 or 7

depending on number of wires.

Splice copper wires to aluminum wiring using special connector terminals

designed and UL-approved for joining copper to aluminum and follow the

connector manufacturer’s recommended procedure closely.

Wire used, location and enclosure of splices, etc., must conform to good wiring practices

and local codes.

Screw

Flexible cable

Bare wire tips

Conduit

Bare wire

Movable nut

Connector block

Bracket

Connector block terminal

Grounding

plate

1 2 ... 46 47 48 49 50 51 52 53 54 55 56 ... 59 60

Pas de commentaire

Ge 49-8779 Manuel d'utilisateur Page 51