Ge JGP329DETBB Manuel d'utilisateur télécharger pdf (Page 14)

Installation Instructions

MAKING THE LP CONVERSION (CONT.)

H CHANGE COOKTOP BURNER

ORIFICES

H Remove the top grates,

burner caps, and burner

heads.

E Remove the spark

igniters from the burner

base (if required to

access the orifices).

Using a No. 15 "Torx"

head driver bit, remove

the screws holding the

burner base in position.

E Using a 7mm nut driver,

remove the top burner

orifices. These may be

accessed through the

hole in the cooktop.

Remove This

Assembly

Orifice Spud Located

Through This Opening

Burner cap

Burner

head i

Spark igniter

18,000 BTU Burner

(on some models)

Spark igniter

Retainer

Ring

[El CHANGE COOKTOP BURNER

ORIFICES (CONT.)

On most burners, the orifices

have a spring-loaded retaining

ring around the hex head

to hold the orifice in the nut

driver during installation and

removal. A slight amount of

force is required to push the nut driver down over

the ring.

NOTE: For orifices that do not have a spring-

loaded retaining ring, use pliers to hold the orifice

in position during initial thread

engagement or final removal to

avoid dropping the orifice in the

cooktop. Then use the nut driver

to tighten or loosen.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 31 32

Commentaires sur ces manuels

Pas de commentaire

Ge JGP329DETBB Manuel d'utilisateur Page 14

Commentaires sur ces manuels

Produits connexes et manuels pour Poêles Ge JGP329DETBB