GE D Guide d'installation télécharger pdf

GENERAL

This luminaire is designed for indoor applications only, and should

be installed and maintained according to these instructions.

The Nuvation™ ballast is designed to operate 250W,300W, 320W,

350W and 400W pulse start and ceramic metal halide lamps with

line voltages from 208-277 volts.

See nameplate for more information.

Any part damaged or broken during or after assembly or installation

should be replaced.

GEH-5956B

INSTRUCTIONS

NOTE: The maximum fixture ambient temperature rating is

the LESSER of the ratings indicated on the ballast and optical

assemblies.

NOTICE: There are no user serviceable parts inside this ballast

housing and there should not be a need to access the inside of

the ballast housing.

Minimum clearance of 3 feet must be maintained below

luminaire.

If the luminaire you ordered has a polycarbonate/acrylic refractor,

please pay particular attention to the following statement:

All -articles made from polycarbonates/acrylics, including

polycarbonate/acrylic resin, will yellow with time. The rate of

yellowing is determined by the specific material, any additives

and coatings, as well as the optical temperature and exposure

to Ultraviolet (UV) light.

This yellowing can reduce the light output and impact resistance

of products made from polycarbonate/acrylic resin. In no case

should the maximum lamp age, wattage rating, or ambient

rating listed for the luminaire be exceeded. Contact factory for

more information.

UNPACKING

This luminaire has been properly packed to avoid damage

during transit. Inspect the luminaire to confirm there is no

damage. Do not install a damaged luminaire or damaged

luminaire components.

NOTE: The Nuvation luminaire is supplied with a Slide-On

Through Wire Box which may be included in the carton ready

to install.

NUVATION

™

Electronically Ballasted Industrial Luminaires

With Electromechanical Sliding Optical Disconnect

Installation and Maintenance

FGE DGE OGE LME VSE

VERSABEAM PROTECTED BY

U.S. PATENT NUMBER 5,416,684

READ THOROUGHLY BEFORE INSTALLING

SAVE THESE INSTRUCTIONS FOR FUTURE USE

WARNING

CAUTION

Risk of burn

• Do not touch operating luminaire

CAUTION

Risk of injury

• Wear safety glasses and gloves

during installation and servicing

Risk of electric shock

• Turn power off before servicing

These instructions do not purport to cover all details or variations in equipment nor to provide for every possible contingency to be met in connection with installation, operation or

maintenance. Should further information be desired or should particular problems arise which are not covered sufficiently for the purchaser’s purposes, the matter should be referred

to GE Lighting Solutions.

Lighting Solutions

1 2 3 4

Résumé du contenu

Page 1 - NUVATION

GENERALThis luminaire is designed for indoor applications only, and shouldbe installed and maintained according to these instructions.The Nuvation™ b

Page 2 - INSTALLATION

INSTALLATION1.A. For Nuvation™ with Dimming Option, remove both wiring boxdoors (Figure 2) for electrical connections and box removal.2. Thread the Wi

Page 3 - DIMMING CONTROL

The Luminaire wattage is preset at the factory. Please contact thefactory for instructions and a retrofit kit if a different wattage isrequired.The N

Page 4 - LAMP/INSTALLATION/REPLACEMENT

35-201578-149 (8/07)LAMPSThe light output of a luminaire is also dependent on the age of theLamp. In applications where the light level is critical,