Ge ZBD9900RII Manuel d'utilisateur télécharger pdf (Page 12)

1. Loosen the mounting screws on the dishwasher’s

two front steel feet using a 5/8 inch (16mm) open-

ended wrench. Screw the mounting screws down

as close to the oor as possible.

2. Adjust the height of the dishwasher by turning

the front steel feet with your hands. Leave enough

space to adjust them later.

LEVEL DISHWASHER

IMPORTANT

– Dishwasher must be level for proper

dish rack operation, wash performance and door operation.

The dishwasher must be leveled left to right and front to back.

This assures the dish racks will not roll in or out on their own,

circulation water will ow to the pump inlet, and the door will

close without hitting the side of the tub.

• Remove the lower dish rack and place a level on the door and

lower rack track.

• Adjust the level of the dishwasher by individually turning the

four legs on the bottom of the dishwasher.

• The dishwasher is properly leveled when the level indicator is

centered left to right and front to back. Also, the dishwasher

door should close without hitting the side of the tub.

• Replace the lower rack.

Tip: Prevent unnecessary service charges. Verify dishwasher

is leveled.

Pull the dish racks half way out . They should stay put. Open

and close the door. The door should t in the tub opening

without hitting the side of the tub. If the racks roll on their own,

or the door hits the side of tub, re-level the dishwasher.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 31 32

Pas de commentaire

Ge ZBD9900RII Manuel d'utilisateur Page 12