Ge ZBD9900RII Manuel d'utilisateur télécharger pdf (Page 5)

Installation Custom Panel

Custom Door Panel Dimensions

Your new Monogram dishwasher can be installed with a fully

integrated, buyer supplied custom door panel or Mongram

accessory panel that extends from the toe kick to the counter

top. The unit comes with everything needed to make installing

the door panel easy.

The custom panel should be a minimum of 3/4” (19mm) thick.

Items provided with the unit

Two 3/8” screws (B) for temporarily hanging the panel.

Six 1-3/4” screws (D) for mounting the custom wooden panel

to the dishwasher.

INSTALLING THE CUSTOM PANEL

OR MONOGRAM ACCESSORY

PANEL

A custom door panel should be installed before the unit is

mounted to the cabinet.

Refer to the illustration at the right for instruction references.

1. Fit the handle (A) onto the panel according to the manu-

facturer’s instructions. (NOTE: A handle should be used rather

than a knob, because a knob does not provide enough grip.)

IMPORTANT! The custom panel must not

obstruct the fan exhaust vent; otherwise,

moisture from the vent could eventually

damage the cabinet and create drying

problems.

2. The two short screws (B) go into the back

of the panel 15-7/16” (392 mm) from the upper edge of the

panel and 10-7/8” (266 mm) from the center of the panel.

Insert the short screws into the panel, leaving 1/8” (3 mm) of

space between the screw head and the panel.

3. Hook the panel screws (B) into the keyholes (C) on the dish-

washer door.

4. Slide the panel to the left until it is centered in the opening

and secure the screws.

5. Open the door and use the six screws (D) supplied to secure

the panel to the door.

6. Exhaust vent can be adjusted by loosening vent screws on

the side of the door and moving the exhaust vent up or down.

Note: If vent is pulled downward too far it will seperate from

the exhaust conduit and must be reattached.

NOTE: If the door panel weighs more than 15 pounds, you

may need to order the heavy-duty door springs (Order Kit #

WD01X10445).

Max panel width cannot exceed cutout dimensions less 1/8”

(2.5mm) reveal on each side.

Weight:

Up to 15 lbs. with unit

15-19 lbs.

Order 1X

WD01X10445

19-23 lbs.

Order 2X

WD01X10445

Custom Panel Dimensions

15-7/16"

392 mm

-7/8"

266

10-7

/8"

266

ADJUSTING THE DOOR SPRINGS

Before you push the dishwasher into the cabinet opening, test

the door to make sure it stays in place at any angle. If it tends

to fall down, pull out the machine and adjust the tension of the

door springs on the sides of the machine by moving them one

hole farther back or by twisting the spring to make it shorter.

Shorten

For dimensional information see pages 3 and 4.

1 2 3 4 5 6 7 8 9 10 ... 31 32

Commentaires sur ces manuels

Pas de commentaire

Ge ZBD9900RII Manuel d'utilisateur Page 5

Commentaires sur ces manuels

Produits connexes et manuels pour Rondelles Ge ZBD9900RII