Ge GXRM10RBL Manuel d'utilisateur télécharger pdf (Page 11)

Installation Instructions

PREFILTER, POSTFILTER AND RO CARTRIDGE REPLACEMENT

PROCEDURE, INCLUDING SANITIZATION

Turn OFF the icemaker (if attached to the

RO system).

Wash your hands with anti-bacterial soap.

Turn off water supply

to RO system.

Remove cap from RO cartridge housing (unscrew

tubing first, on some models). Use pliers to

remove the RO cartridge. Place in a clean plastic

bag or discard if replacing. Thoroughly wipe inside

of housing and cap with a paper towel or dish

brush moistened with dish soap. Rinse well. Install

RO cartridge housing cap.

NOTE: Failure to

remove RO cartridge

during sanitization

will destroy the RO

cartridge.

Turn on RO faucet. Drain tank (may take several

minutes). Turn off RO faucet.

CAUTION: Failure to close the water

supply valve or tank shut-off valve will cause water

to spray or run when sumps are removed.

Remove the sumps.

Be careful—sumps will be full

of water.

Discard filters. Thoroughly

wash sumps with dish soap.

Thoroughly wipe inside of heads

with a paper towel moistened

with dish soap. Rinse well.

Install empty postfilter sump.

Fill prefilter sump with water to within 1”

of O-ring. Add 2 oz. (4 Tbsp.) ordinary household

bleach. Install prefilter sump.

Turn on water supply. Open RO faucet until water

begins to flow, then close. Allow system to fill for

1 minute.

Open faucet and allow water to flow for

10 minutes. Close faucet for one minute more,

then open and allow water to flow for another

10 minutes, or until bleach odor is gone. Turn

off water supply again. Drain RO.

Remove sumps. Insert filters.

Lubricate O-ring with food-grade

silicone grease, if necessary. (Do not

use petroleum jelly.) Tighten sumps

securely.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 63 64

Commentaires sur ces manuels

Pas de commentaire

Ge GXRM10RBL Manuel d'utilisateur Page 11

Commentaires sur ces manuels

Produits connexes et manuels pour Équipement pour l'eau Ge GXRM10RBL