GE JGBP31 P Manuel d'utilisateur télécharger pdf (Page 43)

—

❑

LEVELING THE RANGE

Remove the storage

drawer, broiler drawer

or kick panel.

2. Use a 3/16” open-end

or socket wrench to back

out both rear leveling

legs approximately two

turns.

3. Use a 1%” open-end

or adjustable wrench to

back out the front

leveling legs

turns.

4. Install the oven

shelves in the oven and

position the range

where it will be installed.

5. Check for levelness by placing a spirit level or a

cup, partially filled with water, on one of

the

oven

racks. If using a spirit level, take two readings—with

the level placed diagonally first in one direction and

then the other.

6. Adjust the

leveling’legs

until the range is level.

7. After the range is level, slide the range away from

the wall so that the Anti-Tip device can be installed.

❑

INSTALLING THE ANTI-TIP DEVICE

1. Mark the wall where the WGHT EDGE of the

range is to be located. Be sure to allow for the

countertop overhang if you intend to install the

range next to cabinets.

WARNING:

● Range must be secured with an approved

Anti-Tip device.

Unless properly installed, the range could be

tipped by you or a child standing, sitting or

leaning on an open door.

● After installing the Anti-Tip device, verify that

it is in place by carefully attempting to tilt the

range forward.

● This range has been designed to meet all

recognized industry tip standards for all normal

conditions.

● The use of this device does not preclude

tipping of the range when not properly installed.

● If the Anti-Tip device supplied with the range

does not fit this application, use the universal

Anti-Tip device

WB02X7909.

bcate

the outside edge of the device 2%”

toward the center of the range from the marked

edge of the range.

3. Using the device as a template, mark the

position of the hole for the screw.

4. For wood construction, drill a pilot hole at an

angle of 20 degrees from the horizontal. A nail or

awl may be used if a drill is not available.

Mount the

hti-Tip

device

witi

the screw provided.

For cement or concrete construction, you

will need a 1/4” x 1%” lag bolt and a 1/2”

O.D.

sleeve anchor, which are not provided. Drill

the recommended size hole for the hardware.

Install the sleeve anchor into the drilled hole and

then install the lag bolt through the device. The

bolts must be properly tightened as recommended

for the hardware.

5. Slide the range against the wall, and check for

proper installation by grasping the front edges of

the rear surface unit openings and carefully

attempting to tilt the range forward.

WHEN

HOOKUPS ARE

~M~ETE~

SURE

CONTROLS ARE LEFT

THE OFF

POSITION.

SURE THE FLOW OF

~MBUSTION

AND

VENTIUTION

TO THE RANGE IS

UNONTRU~ED.

(continued next page)

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 51 52

Commentaires sur ces manuels

Pas de commentaire

GE JGBP31 P Manuel d'utilisateur Page 43

Commentaires sur ces manuels

Produits connexes et manuels pour Cuisiniers GE JGBP31 P