Ge 206C1559P195 Manuel d'utilisateur télécharger pdf (Page 6)

Installation Preparation – Hot Water Supply

PREPARE HOT WATER SUPPLY

Hot Water Line

• The line may enter from either side, rear or floor

within the shaded area shown in Figure F.

• The line may pass through the same hole as the

electrical cable and drain hose, or cut an additional

1-1/2" diameter hole to accommodate the water

line. If a power cord with plug is used, the water line

must not pass through the power cord hole.

Figure F

Water Line Connection

• Turn off the water supply.

• Install a hand shut-off valve in an accessible

location, such as under the sink. (Optional, but

strongly recommended and may be required by

local codes.)

• The water connection is on the left side of the

dishwasher. Install the hot water inlet line, using

3/8" or larger copper tubing. Route the line as

shown in Figure F and extend forward at least 19"

from rear wall.

• Adjust the water heater to deliver water between

120°F and 150°F.

• Flush water line to clean out debris. Use a bucket

to catch water and debris.

• The hot water supply line pressure must be

between 20 and 120 PSI.

661Dia56

Cabinet Face

Shut-off

Valve

2" From Floor

19" From Wall

From

Cabinet

1-1/2" Dia.

Hole

Hot

CAUTION

The hot water supply line pressure must be at least 20 PSI.

Lower pressures could cause the water valve to leak and

cause water damage.

PRECAUCIÓN

La línea de presión del suministro de agua caliente debe

ser al menos 20 PSI. Presiones inferiores podrían causar

que la válvula del agua gotee y causar daños por agua.

1 2 3 4 5 6 7 8 9 10 11 ... 31 32

Commentaires sur ces manuels

Pas de commentaire

Ge 206C1559P195 Manuel d'utilisateur Page 6

Commentaires sur ces manuels

Produits connexes et manuels pour Lave-vaisselle Ge 206C1559P195