GE PROFILE PDE9900 Manuel d'utilisateur télécharger pdf (Page 14)

– 14 –

Water Hardness Test and Calibration

Test Water Hardness

The automatic liquid dishwashing detergent

dispenser (SmartDispense

) dispenses the optimum

amount of detergent to clean the dishes. This

amount of detergent introduced during each cycle

is based on the soil level of the dishes and the

hardness of the water. Therefore, the correct water

hardness setting is very important for both optimum

cleaning of dishes and detergent usage.

Prior to the ﬁ rst use, this dishwasher must be

calibrated for water hardness. This process requires

the use of a water hardness test strip (part #

WD01X10295). This part can by shipped by mail.

The 4 light green stripes will change color. The

harder the water, the more stripes will change from

green to red.

Water hardness should be tested following the

instructions on the test strip package shown above.

Note: If all stripes remain green after the test, the

outcome is "0 RED". The value to be entered into the

dishwasher is "1".

Convert the test reading according to the table

below.

Water Hardness Test Strip Indication

Red Stripes on Strip Value to Enter into Dishwasher

Note: 1 grain per gallon = 17.1 parts per million.

SmartDispense

Calibration

The calibration process will differ slightly depending

on whether the dishwasher is front mount control

(PDW8000 series) or top mount control (PDW9000

series).

Front Mount Control (PDW8900)

Dishwasher must be in standby mode. Close and

latch the door. Press normal wash to illuminate the

lights on the control panel.

Press Cookware pad and Delay Hours pad

together and hold for 3 seconds.

The current hardness setting will be shown on

the Time Remaining display.

Enter the value from the test strip using the

Cookware pad to increase the value or the

Normal Wash pad to decrease the value.

Press the Start/Reset pad to return the

dishwasher to normal operation. The last

displayed value will be saved as the water

hardness value.

Top Mount Control (PDW9700, PDW9900)

Dishwasher must be in standby mode. Press up

arrow to wake up control and illuminate the lights

on the control panel.

LOW DETERGENT

Smart Dispense

ENSING

ASHING

RYING

ANITIZED

LEAN

RINSE ONLY

SINGLE RACK WASH

PLASTIC CYCLE

CHINA CYCLE

SPEED CYCLE

NORMAL

OOKWARE

NTI-

ACTERIAL

Press the up arrow pad and Delay Hours

together and hold for 3 seconds.

The current hardness setting will be shown on

the Time Remaining display.

Enter the value from the test strip using the up

arrow pad to increase the value or the down

arrow pad to decrease the value.

Press the Start/Reset pad to return the

dishwasher to normal operation. The last

displayed value will be saved as the water

hardness value.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 36 37

Commentaires sur ces manuels

Pas de commentaire

GE PROFILE PDE9900 Manuel d'utilisateur Page 14

Commentaires sur ces manuels

Produits connexes et manuels pour Lave-vaisselle GE PROFILE PDE9900