GE PROFILE PDE9900 Manuel d'utilisateur télécharger pdf (Page 28)

– 28 –

Active Vent

The active vent consists of the fan, motor, housing,

and vent louver motor.

The active vent helps to reduce the noise level and

heat loss when in the closed position. The control

module supplies +/- 12 VDC to the vent louver

motor. The control module reverses polarity to drive

the motor in a clockwise or counterclockwise (open

or closed) direction.

The vent closes 8 seconds after the main pump

is switched on during the ﬁ rst ﬁ ll cycle and opens

during the drying cycle (heated and non-heated).

The vent is open during cooldown periods or when

the unit is not in use.

If the vent is closed and the door is opened during

the wash cycle, the vent will open. When the door

is closed again, the vent will remain open for 8

seconds, then close again to ﬁ nish the cycle.

It is normal for water vapor to come through the

active vent during the dry cycle. The active vent can

be opened and closed using the

Service Mode.

The vent louver is held in place by a single screw.

Remove the motor from the mount by rotating the

motor 90° in the mount and sliding it out between

the tabs.

Note: The gear in the mount is held in place with the

motor.

Vent Motor Strip Circuit

J5-2

RED BLK

M J5-1

Note: Foam with double-sided tape holds the

conduit in place. The foam tears easily if pulled

during removal of the housing.

Six Phillips head screws hold the fan and motor to

the vent housing.

Fan Motor Strip Circuit

65 W

FAN

DK. BLUE/RED

WHITE

J2-3

Note: This also applies to the Rinse Only cycle.

Since heated dry is not an option with Rinse Only,

the fan will run for approximately 4 hours before

turning off.

To access the vent fan and motor, remove the door

panel (see Door Panel).

The vent fan and motor housing are held in place

by:

• 4 long, silver Phillips head screws.

• 2 short, brass Phillips head screws (see photo).

Fan (PDW9700 AND PDW9900 Series)

During natural dry, the fan runs for approximately

4 hours after the last drain cycle is completed

(clean light on). During heated dry, the fan runs for

approximately 2 hours after the last drain cycle is

completed. If the door is opened, the fan stops and

the control stops counting down. When the door is

relatched, the fan will start again and the control will

continue to count down. Touching any key will turn

off the fan.

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 36 37

Commentaires sur ces manuels

Pas de commentaire

GE PROFILE PDE9900 Manuel d'utilisateur Page 28

Commentaires sur ces manuels

Produits connexes et manuels pour Lave-vaisselle GE PROFILE PDE9900