Ge DPGT650 Manuel d'utilisateur Page 14

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 72
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 13
BEFORE YOU BEGIN
Read these instructions completely and carefully.
IMPORTANT Save these instructions for
local electrical inspector’s use.
IMPORTANT Observe all governing codes
and ordinances.
Note to Installer Be sure to leave these
instructions with the Consumer.
Note to Consumer Keep these instructions for
future reference.
This dryer must be exhausted to the outdoors.
Before the old dryer is removed from service or
discarded, remove the dryer door.
Service information and the wiring diagram are
located in the control console.
Do not allow children on or in the appliance. Close
supervision of children is necessary when the
appliance is used near children.
Proper installation is the responsibility of
the installer.
Product failure due to improper installation
is not covered under the Warranty
.
Gas dryers are not approved for mobile home
installation.
Installation Dryer
Instructions
DPGT650 and UPGT650
14
Questions? Call 800.GE.CARES (800.432.2737) or visit our Web site at: ge.com
In Canada, call 1.800.561.3344, or visit geappliances.ca
FOR YOUR SAFETY:
WARNING
Use only rigid metal or flexible metal 4-inch
diameter ductwork for exhausting to the
outdoors. Never use plastic or other combustible
easy-to-puncture ductwork.
This appliance must be properly grounded and
installed as described in these instructions.
Do not install or store appliance in an area where
it will be exposed to water and/or weather.
The National Fuel Gas Code restricts installations
of gas appliances in garages. They must be 18
inches off the ground and protected by a barrier
from vehicles.
Install the dryer where the temperature is above
50°F for satisfactory operation of the dryer
control system.
FOR GAS MODELS ONLY:
NOTE: Installation and service of this dryer must
be performed by a qualified installer, service
agency or the gas supplier.
In the Commonwealth of Massachusetts:
This product must be installed by
a licensed plumber or gas fitter.
When using ball-type gas shut-off valves,
they shall be T-handle-type.
A flexible gas connector, when used,
must not exceed 3 feet.
Vue de la page 13
1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 71 72

Commentaires sur ces manuels

Pas de commentaire