Ge DPGT650 Manuel d'utilisateur télécharger pdf (Page 25)

Installation Instructions

USING FLEXIBLE METAL DUCT FOR

TRANSITION VENTING

Rigid or semi-rigid metal ducting is

recommended for use as transition ducting

between the dryer and the wall. In special

installations when it is impossible to make a

connection with the above recommendations,

then a UL-listed flexible metal transition duct may

be used between the dryer and wall connection

only. The use of this ducting will affect dry time.

If flexible metal transition duct is necessary,

the following directions must be followed:

• Use the shortest length possible.

• Stretch the duct to its maximum length.

• Do not crush or collapse.

• Never use flexible metal ducting inside the wall

or inside the dryer.

• Avoid resting the duct on sharp objects.

• Venting must conform to local building codes.

FOR TRANSITION VENTING

(DRYER TO WALL), DO:

•DO cut duct

as short as

possible and

install straight

into wall.

•DO use elbows

when turns are

necessary.

DO NOT:

•DO NOT bend or

collapse ducting.

Use elbows if

turns are

necessary.

•DO NOT use

excessive

exhaust length.

Cut duct as short

as possible.

•DO NOT crush

duct against

the wall.

•DO NOT set

dryer on duct.

Elbows

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 71 72

Commentaires sur ces manuels

Pas de commentaire

Ge DPGT650 Manuel d'utilisateur Page 25

Commentaires sur ces manuels

Produits connexes et manuels pour Séchoirs Ge DPGT650